[rainlake]

long story short. I got a rt3050f based router(tenda 3g150m). I messed up mtds,there were 4 mtds. (uboot,config,Factory,Kernel). I flased Factory and Kernel with some firmware. it can not boot right now.

I tried to debrick in uboot. but whatever I tried, uboot seems to not working. It just stopped after tftp firmware.
I tried press 2 to reflash and press 4 and tftp firmware into memroy in command line. all of them just stopped after tftp.

I tried tftp a all zero file(created by dd if=/dev/zero of=test.bin bs=1k count=2000), tftp was successed.

what can i do now?

here is some log.
RT3052 # tftpboot test.bin

netboot_common, argc= 2

NetTxPacket = 0x81FE4400

KSEG1ADDR(NetTxPacket) = 0xA1FE4400

NetLoop,call eth_halt !

NetLoop,call eth_init !
Trying Eth0 (10/100-M)

Waitting for RX_DMA_BUSY status Start... done

Header Payload scatter function is Disable !!

ETH_STATE_ACTIVE!!
Using Eth0 (10/100-M) device
TFTP from server 192.168.234.1; our IP address is 192.168.234.132
Filename 'test.bin'.

TIMEOUT_COUNT=10,Load address: 0x0
Loading: Got ARP REPLY, set server/gtwy eth addr (xx:xx:xx:xx:xx:xx)
Got it
T #
first block received
################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#############
done
Bytes transferred = 2394516 (248994 hex)
NetBootFileXferSize= 00248994