Posted: Sat Apr 09, 2011 8:44 Post subject: Linksys e1000v2 now supported
Linksys e1000v2 is now supported. Please use attached firmware for flashing. You can simply update from original firmware GUI. After flashing be sure to restore to factory defaults.
This cpu can obviously be used together with an external switch ic which then can be a gigabit switch but the built-in switch is only 100Mbps. _________________ Kernel panic: Aiee, killing interrupt handler!
Posted: Thu Apr 14, 2011 19:35 Post subject: Re: E1000v2.1
Eko wrote:
mike5757 wrote:
I doubt the answer to the question I'm about to ask is yes, but will this build work on the E1000 v2.1?
not without some tweaking -
Damn, I just bought one thinking the subversions would also be compatible. I was able to flash it for v2 but the repeater bridge is not working. I guess I'll have to wait, thanks for all your work.
This is the Model I purchased:
MODEL: E1000 v2
It's refurbished but at the linksys site is located with the ID: E1000-RM V2
I flashed my router and it is currently working, however I was wondering if its possible to upgrade to a larger version of dd-wrt or do I have to stay with the mini version on this router for now?
Joined: 26 Jan 2008 Posts: 13049 Location: Behind The Reset Button
Posted: Fri Apr 22, 2011 12:55 Post subject:
FlyingDonkey wrote:
I flashed my router and it is currently working, however I was wondering if its possible to upgrade to a larger version of dd-wrt or do I have to stay with the mini version on this router for now?
You must run a build 16758 or later. You can run some of the "small" std builds (K26).. std_nokiad_small, std_openvpn_small.
The router has 4mb flash. _________________ [Moderator Deleted]