Power ON router and wait to fast blinking led.
On Computer run TFTP server and share file named "rftest"
Change computer IP to 192.168.0.100
Wait 20 sec
LED are stop blinking.
Now You can login on 192.168.0.1
WiFi SSID is: TP-LINK_FFFF and TP_LINK_FFFF_5G
WiFi Password is 12345670
WPS PIN is 12345670
One BIG Bug - Cannot upgrade this firmware, because Hardware Version and Firmware Version is blank.
@kuennek Have You same MAC adress on DDWRT and label on backside router?
Can You run SSH and type command:
cat /dev/mtd1 > /tmp/mtd1.bin
And using WinSCP copy this file to computer and send to forum ( use mega.nz or other file sharing)
I prepare file to use on command mtd -r write .... , Not share this file, because I dont know if You have "Hardware Version" on your flash.
if WiFi not work. Try upload radio data:
https://mega.nz/#!dVQWHKqS!kWsORP2m8u-9qeB1X_pjL_FZZ_q9E102mNSFzQ2fksU
Command:
flash -noheader -offset=0xfe0000 192.168.0.66:mtd3.bin flash0
No I need to hardware flash the router. I have a few USB serial adapters around here somewhere but they are buried in a box that I havent unpacked yet, so I just orderd another one. Should hopefully be here tomorrow or Friday. So when I get it back up and running I'll let you know.
if anyone make a webrevert and i flash to Stock Firmware via Webrevert I brick the Router too?
Yes
anonon wrote:
Damage to any of the following may also cause issues, since they're contained in the TP-Link partition table but not updated by firmware updates nor properly represented in the MTD partition map:
Code:
partition default-mac base 0xe40000 size 0x00200
partition pin base 0xe40200 size 0x00200
partition product-info base 0xe40400 size 0x00200
partition profile base 0xe70000 size 0x10000
partition default-config base 0xe80000 size 0x10000
partition user-config base 0xe90000 size 0x50000
partition log base 0xee0000 size 0x100000
partition radio_bk base 0xfe0000 size 0x10000
partition radio base 0xff0000 size 0x10000
If You have only broken 0xe40000 size 0x10000 and write stock firmware. System Tools - Firmware Upgrade dont work.
If You have only broken 0xF80000 size 0x10000 and write stock firmware. Router stop booting and power led start fast blinking.
i think i have only broken 0xe40000 size 0x10000,if i Flash Firmware overt tftp Server Im only on DD-WRT.But how can it Happenend to Change the Mac adress?Is it Right the Mac Adress is Standing in Status under Router on dd-wrt?
Which USB-UART TTL i Need?Can i check again with this command the Mac adress?
Can You run SSH and type command:
cat /dev/mtd1 > /tmp/mtd1.bin
but what is SSH?If i Type the command on CMD not working