Flashed on the Asus RT-AC68U, worked fine, but after a reboot was not included. Only after the hard reset.
Other firmware is not loaded. Performed through the dd-wrt "nvram erase", hoping for a correct restart, but now the router is blinking LED on the cover and everything. Firmware uploaded via TFTP (even tried the original), but it still flashes and nothing happens. 30/30/30 does not help
Even Though Fractal had one for porting, so obviously even the internal tracking information is screwed up.
As for the other references, I suspect someone has been going in and editing the data, since the WIKI can be edited WITHOUT a password….
I too have one of these pieces of crap.
I suppose I could port it , but routers are not the normal embedded products I work with, nor have I worked with the DD-WRT code base.
I have top hat kit that can pull the sector image off the spansion chip ( for recovery), and JTAG kit coming out of my ears
But you have to be careful with that sort of thing, since each Nand-flash chip is actually unique as regards hard errors.
I spoke to fractal 2 weeks ago. He said he was going to try to port it, as he had one, if not he was going to ask Kong if he wanted it. _________________ I am far from a guru, I'm barely a novice.
I have a Linksys EA6400 and like so many owners, I'm not impressed with the capabilities of the firmware. Since someone in this thread apparently successfully installed a dd-wrt for an Asus RT-AC56U on a Linksys EA6300, I decided to give it a go. And to my big surprise: WITH SUCCES!!!
Here's what I did:
reset the Linksys firmware to factory settings via the Linksys GUI