Posted: Tue Jul 04, 2006 11:49 Post subject: Linksys WRT54G: dead after applying settings !?
I just flashed a Linksys WRT54G v5 with the v23_micro_generic.bin firmware. I followed the procedure using Vxworkskiller and everything went fine. The router was flashed with the new firmware and i had access to the dd-wrt interface.
I started to set up the router, and it rebooted 2 or 3 times without problem after i apllied the new settings. Then suddently, after setting up the router as a dhcp forwarder and applying the settings, it refused to restart.
Since then, all lights are turned on and the ethernet interface is down (no signal). I tried to use the reset button, but it didn't solve the problem.
However, the power led isn't blinking. So, according to the doc, it might be recoverable. (?)