Posted: Sat Jan 22, 2011 14:22 Post subject: EOC2611P - Entered Redboot but flash fails
Hi all,
I'm trying to recover from a failed dd-wrt firmware upgrade (power failure during flash).
I succesfully entered the Redboot shell following the instructions in the sticky.
I download the EOC2610 linux.bin image (I have a 2611P device which should be compatible).
RedBoot> fis init
About to initialize [format] FLASH image system - continue (y/n)? y
*** Initialize FLASH Image System
... Erase from 0xa87e0000-0xa87f0000: .
... Program from 0x80ff0000-0x81000000 at 0xa87e0000: .
13. Download the image from TFTP server and copy into memory
RedBoot> load -r -b 0x80041000 linux.bin
Using default protocol (TFTP)
-
Raw file loaded 0x80041000-0x80663fff, assumed entry at 0x80041000
14. Create a partition in flash
RedBoot> fis create linux
Note: This step will take about 10~15 minutes to complete, please wait patiently.
... Erase from 0xa8030000-0xa8653000: .....................................
... Program from 0x80041000-0x80664000 at 0xa8030000: .................
Step 14 fails: "Can't program region at 0xa8070000: Unknown error"
Any help would be appreciated getting past this issue.
Posted: Sat May 12, 2012 18:27 Post subject: Help... thanks
I have an engenius eoc2611p. The device wont let me into it, I tried reseting it using the physical button but that still doesnt seem to work. The device was working just fine, but I wanted to move to a different location and have it connect to a different access point, so I just pushed the button to reset.
I am now looking on the internets for help. I saw that you were talking about recovering from a bad flash, and I would like some help doing that. I do not know where the documentation you are talking about is. Any help would be greatly appreciated.
I can ping the device for about 2 seconds or less when it boots up, but that is all. after that nothing.
Posted: Wed Jan 16, 2013 13:49 Post subject: Re: EOC2611P - Entered Redboot but flash fails
remco.kortekaas wrote:
I download the EOC2610 linux.bin image (I have a 2611P device which should be compatible).
Hi Remco,
I also have a EOC2611P, would you be so kind to post the "linux.bin" file here?
I am looking for it everywhere but i can't find it, the only thing available was the original firmware in .img format, thanks.