Well, find someone who knows how to solder, and ask him to fill the hole with solder. Then connect the wires, and see if it shows the boot process in the terminal.
Well, find someone who knows how to solder, and ask him to fill the hole with solder. Then connect the wires, and see if it shows the boot process in the terminal.
You still have 50% of chances to make it work.
So just solder cables on places ( TX, RX ) and watch boot process, right ? Is there any problem with whis road ?
Yes, but don´t do any other holes. As I said, depending of what was in the other side of the board, you still have a 50% chance of it working.
What is this road function ? Is it important ? What is do if it do not work ? So Solder wires and nothing else ?
What will do if I fully damage this road
If it is there, it is necessary. If you damaged the traces ( the "road", as you call it) , find someone good with a solder iron to fix it ( reconnect the two pieces, with solder or a tiny wire ) .
You can try it yourself. You don´t have much to lose, now. Pray to the gods, fix the board the best you can, connect the wires and try.
If it is there, it is necessary. If you damaged the traces ( the "road", as you call it) , find someone good with a solder iron to fix it ( reconnect the two pieces, with solder or a tiny wire ) .
You can try it yourself. You don´t have much to lose, now. Pray to the gods, fix the board the best you can, connect the wires and try.
Posted: Tue Jan 24, 2012 11:14 Post subject: Re: TendaW311R+
anas808 wrote:
thank you mr RogFanther but
iuse rong softwaer and iwant to copy the flash im not loking for the softwaer im looking for flash copy the all dump
So you want to have copy, if you damage something to repair it ?
Tenda HAVE NOT JTAG, so if you damage something with U-BOOT this is the end of the router.
P.P If you want to upgrade firmware, please contact Tenda on skype: tendacz or e-mail ( see it in Tenda site ). I updated my firmware, but I flash with wrong and damage router.