Questions about EnGenius ESR9752

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Ralink SoC based Hardware
Author Message
sk2020
DD-WRT Novice


Joined: 19 Oct 2009
Posts: 5

PostPosted: Fri Oct 23, 2009 13:11    Post subject: Questions about EnGenius ESR9752 Reply with quote
Hi all
I just flashed a ESR9752 through serial cable. Bascially, it works fine. But, I found somethings strange.
1. the LED of LAN is never up and the LED of WAN is never down.
2. I could run "chilli" on the device but WPA2 has been failed. I have found that no "nas" is found in the AP. Is it missed?
3. I would assign one LAN port to WAN side. However, the port is still connected to LAN side after booted.

Anyone has similar problems before ?
Thanks
SK
Sponsor
brispet1
DD-WRT Novice


Joined: 11 Mar 2008
Posts: 16

PostPosted: Fri Oct 23, 2009 13:46    Post subject: Reply with quote
wpa is super flaky in ddwrt, and AFAIK has never worked (at least reliably) in a chillispot scenario with repeaters. As far as assigning a lan port to the wan bridge does this device use/support vlans?
sk2020
DD-WRT Novice


Joined: 19 Oct 2009
Posts: 5

PostPosted: Mon Oct 26, 2009 5:15    Post subject: Reply with quote
Hi all
The vlan page has been dismissed. And, the vlan commands do not work.
Anyone has experienced it before?
Would it be fixed in comming version?
Thanks
B.Regards,
SK
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Ralink SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum