Posted: Fri Oct 23, 2009 13:11 Post subject: Questions about EnGenius ESR9752
Hi all
I just flashed a ESR9752 through serial cable. Bascially, it works fine. But, I found somethings strange.
1. the LED of LAN is never up and the LED of WAN is never down.
2. I could run "chilli" on the device but WPA2 has been failed. I have found that no "nas" is found in the AP. Is it missed?
3. I would assign one LAN port to WAN side. However, the port is still connected to LAN side after booted.
wpa is super flaky in ddwrt, and AFAIK has never worked (at least reliably) in a chillispot scenario with repeaters. As far as assigning a lan port to the wan bridge does this device use/support vlans?
Hi all
The vlan page has been dismissed. And, the vlan commands do not work.
Anyone has experienced it before?
Would it be fixed in comming version?
Thanks
B.Regards,
SK