Posted: Tue Nov 18, 2008 20:26 Post subject: express.sh: Express numbers visually using GPIO!
express.sh allows you to "express" numbers (and periods ".") on your router via blinking LED, using gpio.
The designated LED will light for 2 seconds to denote the beginning of an "expression". Then, it will "express" your number. Finally, it will light for 2 seconds to denote the end.
Periods are expressed via a 1 second long light.
0 is expressed as 10 blinks.
Example:
/jffs/express.sh 7 1.30
This will use the WRT54G's DMZ light (gpio 7) to express "1.30". It will light the DMZ light for 2 seconds, blink once, pause, stay on for 1 second, pause, blink three times, pause, then blink 10 times.
Useful for expressing any number:
Router WAN IP (example .sesbutton script included!)
Router LAN IP
Client mode signal strength
Number of associated wireless clients
Number of logged-in users
etc..
Joined: 07 Jun 2006 Posts: 1488 Location: the Netherlands
Posted: Wed Nov 19, 2008 10:20 Post subject:
You do have to take in consideration that when you have a MMC mod, messing with the DMZ-light and the SES-light might cause data corruption on your mmc-card! _________________ Firmware: DD-WRT v24-sp2 (latest available) mega
WRT320N