WRT600N tracert exploit with stock Linksys firmware

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware
Goto page Previous  1, 2, 3 ... 13, 14, 15 ... 19, 20, 21  Next
Author Message
CaScAdE
DD-WRT Guru


Joined: 18 Jun 2006
Posts: 1110
Location: Kiel (54.4247,10.1721)

PostPosted: Mon Jun 02, 2008 20:43    Post subject: Reply with quote
You are talking about
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=175173#175173
right?
Will give it a try, tftp is done, now waiting for changes... but afair i have tried that one already...
too bad that i cannot access the device via serial line...


Thanks man!!!!!!!! I must have messed up the files i had here... Now it is alive again!
I am cleaning up my dd-wrt folder now *g*



IMG_9561.JPG
 Description:
happily blinking again :-)
 Filesize:  29.85 KB
 Viewed:  45005 Time(s)

IMG_9561.JPG



_________________
DD-WRT F.A.Q.

Webcam Kiel
Sponsor
jmh9072
DD-WRT Guru


Joined: 04 Sep 2007
Posts: 800
Location: Ohio

PostPosted: Mon Jun 02, 2008 21:20    Post subject: Reply with quote
CaScAdE wrote:
Thanks man!!!!!!!! I must have messed up the files i had here... Now it is alive again!
I am cleaning up my dd-wrt folder now *g*

Glad to hear it. You're welcome.

_________________
WRT54G v3 - v24 r14471M NEWD Eko - AP
WRT350N v1.0
WRT600N v1.1 - halfway there!
Se7en is Darker...
maclover201
DD-WRT Novice


Joined: 10 Mar 2008
Posts: 40
Location: Denver, CO

PostPosted: Mon Jun 02, 2008 21:54    Post subject: Before I flash... Reply with quote
I have a question. What bugs have been resolved with the WRT600N since v24 rc7? v24 is out now and I am contemplating an upgrade...


    Ethernet switch doesn't work
    300 mbps Wireless-N performs at 100 mbps
    Storage Link Unsupported
    No FTP Communication to USB hard drive/flash drive


I have a WRT300N V1.1 with Build 3 Firmware, interestingly enough. Do I need to downgrade to a prior build before doing anything or just use the traceroute trick to upgrade? The straight dope would be best.

Thanks!

-Morgan
BrainSlayer
Site Admin


Joined: 06 Jun 2006
Posts: 6978
Location: Dresden, Germany

PostPosted: Wed Jun 04, 2008 12:29    Post subject: Reply with quote
the attached firmware should work and should also be flashable without any exploit


dd-wrt.v24_mini_wrt600n.bin
 Description:

Download
 Filename:  dd-wrt.v24_mini_wrt600n.bin
 Filesize:  2.8 MB
 Downloaded:  2529 Time(s)


_________________
"So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
radiowave
DD-WRT User


Joined: 21 Apr 2008
Posts: 230
Location: Riding the 802.11 waves...

PostPosted: Wed Jun 04, 2008 13:31    Post subject: Reply with quote
I am going to give this a try. BrainSlayer are the LAN ports and WAN port working with this new mini file? Also, if the LAN and WAN ports are working in this new mini file will loading the mega version over this mini turn off the LAN ports?
CaScAdE
DD-WRT Guru


Joined: 18 Jun 2006
Posts: 1110
Location: Kiel (54.4247,10.1721)

PostPosted: Wed Jun 04, 2008 14:18    Post subject: Reply with quote
radiowave wrote:
I am going to give this a try. BrainSlayer are the LAN ports and WAN port working with this new mini file? Also, if the LAN and WAN ports are working in this new mini file will loading the mega version over this mini turn off the LAN ports?


WAN and LAN will work with this very image, if you flash any current different version you will loose that functionality...

It has already been tested:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=181031#181031
and it runs on one of mine at home where BS tested the stuff.
So flash it and wait for a fixed mega to come out Smile

_________________
DD-WRT F.A.Q.

Webcam Kiel
radiowave
DD-WRT User


Joined: 21 Apr 2008
Posts: 230
Location: Riding the 802.11 waves...

PostPosted: Wed Jun 04, 2008 15:05    Post subject: Reply with quote
Excellent...thanks this is good news for WRT600N owners....I will give this a try for sure....I there any USB storage support in this build?
killer23d
DD-WRT Novice


Joined: 18 Sep 2007
Posts: 30

PostPosted: Wed Jun 04, 2008 20:16    Post subject: Reply with quote
Thank you so much BS!!! So far everything is working great. I get WAN IP, LAN IP, both 5Ghz and 2.4Ghz connected.

Things I see that need a fix:
- Blinking power LED
- Remove SuperChannel/WiMax pages

Again, I used the instruction I posted in here to flash it. http://www.dd-wrt.com/phpBB2/viewtopic.php?t=31079&highlight=wrt600n
jmh9072
DD-WRT Guru


Joined: 04 Sep 2007
Posts: 800
Location: Ohio

PostPosted: Wed Jun 04, 2008 21:18    Post subject: Reply with quote
killer23d wrote:
Thank you so much BS!!! So far everything is working great. I get WAN IP, LAN IP, both 5Ghz and 2.4Ghz connected.

Things I see that need a fix:
- Blinking power LED
- Remove SuperChannel/WiMax pages

Again, I used the instruction I posted in here to flash it. http://www.dd-wrt.com/phpBB2/viewtopic.php?t=31079&highlight=wrt600n

You actually didn't have to use that exploit. The file is trailed so the router would have accepted it through the web interface or TFTP.

_________________
WRT54G v3 - v24 r14471M NEWD Eko - AP
WRT350N v1.0
WRT600N v1.1 - halfway there!
Se7en is Darker...


Last edited by jmh9072 on Thu Jun 05, 2008 1:02; edited 2 times in total
killer23d
DD-WRT Novice


Joined: 18 Sep 2007
Posts: 30

PostPosted: Wed Jun 04, 2008 22:23    Post subject: Reply with quote
Thanks!!

After using it with my laptops, I am pleased with the performance over the dreaded Linksys firmware.

The only thing I noiced that may need to be updated on future version:
- 20Mhz/40Mhz selection
- A, B, G, N, Mixed mode selection

I think the 20Mhz/40Mhz selection is the most important because that allow us to connect as fast as 270Mbps. Now my connection speed is no different than WRT350N @ 130Mbps.

What is the best TX ouput power for the WRT600N? I have it at 70 and 100 and doesn't seem to make the connection better.
jmh9072
DD-WRT Guru


Joined: 04 Sep 2007
Posts: 800
Location: Ohio

PostPosted: Wed Jun 04, 2008 23:05    Post subject: Reply with quote
killer23d wrote:
Thanks!!

After using it with my laptops, I am pleased with the performance over the dreaded Linksys firmware.

The only thing I noiced that may need to be updated on future version:
- 20Mhz/40Mhz selection
- A, B, G, N, Mixed mode selection

I think the 20Mhz/40Mhz selection is the most important because that allow us to connect as fast as 270Mbps. Now my connection speed is no different than WRT350N @ 130Mbps.

What is the best TX ouput power for the WRT600N? I have it at 70 and 100 and doesn't seem to make the connection better.

Well, Linksys has it set to 100mW by default, but I used the exploit to change that to84 mW (I'm still running stock firmware, but that will change soon). If 70mW is working for you, then leave it at that. If you're not working over long distances, you might even try 28mW. It'll keep the radio cooler and make it last longer. However, if that makes your performance take a hit, then I'd go back to 70mW.

_________________
WRT54G v3 - v24 r14471M NEWD Eko - AP
WRT350N v1.0
WRT600N v1.1 - halfway there!
Se7en is Darker...
maclover201
DD-WRT Novice


Joined: 10 Mar 2008
Posts: 40
Location: Denver, CO

PostPosted: Thu Jun 05, 2008 0:03    Post subject: Cool! Reply with quote
Ok... cool. Does USB storage work? Can you create shares and stuff like with the stock firmware? How about the 5 Ghz channel? Does it perform at 300 mbps? Can you flash the mega version after the mini version and still have all the features? Is there a supported mega version? :D

Questions, questions, questions.

Sorry, I just tuned in.

-Morgan

_________________
First Network:
Linksys WRT600N V1.1 as Router - DD-WRT v24 mega
Asus WL-330g as AP - Stock Firmware
Linksys WAP54G V3.1 as AP - DD-WRT v24 micro
Linksys WRT54G V4.0 as AP - DD-WRT v24 std

Second Network:
D-Link DIR-655 as Router - Stock Firmware
CaScAdE
DD-WRT Guru


Joined: 18 Jun 2006
Posts: 1110
Location: Kiel (54.4247,10.1721)

PostPosted: Thu Jun 05, 2008 8:13    Post subject: Re: Cool! Reply with quote
maclover201 wrote:
Ok... cool. Does USB storage work? Can you create shares and stuff like with the stock firmware?


According to mega images: Yes / No.
There is not samba/nfsd/upnp/ftp daemon included in DD-WRT right now. You can mount the ext2/3 or vfat devices and install samba etc manually...

maclover201 wrote:
Is there a supported mega version? Very Happy


Only nvram stuff needs to be changed. So you can flash this one and afterwards a mega should work... look at:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=181271#181271

_________________
DD-WRT F.A.Q.

Webcam Kiel
BrainSlayer
Site Admin


Joined: 06 Jun 2006
Posts: 6978
Location: Dresden, Germany

PostPosted: Thu Jun 05, 2008 12:04    Post subject: Reply with quote
mega build


dd-wrt.v24_mega_wrt600n.bin
 Description:

Download
 Filename:  dd-wrt.v24_mega_wrt600n.bin
 Filesize:  5.76 MB
 Downloaded:  2355 Time(s)


_________________
"So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
maclover201
DD-WRT Novice


Joined: 10 Mar 2008
Posts: 40
Location: Denver, CO

PostPosted: Thu Jun 05, 2008 16:02    Post subject: Re: Cool! Reply with quote
CaScAdE wrote:
maclover201 wrote:
Ok... cool. Does USB storage work? Can you create shares and stuff like with the stock firmware?


According to mega images: Yes / No.
There is not samba/nfsd/upnp/ftp daemon included in DD-WRT right now. You can mount the ext2/3 or vfat devices and install samba etc manually...

maclover201 wrote:
Is there a supported mega version? Very Happy


Only nvram stuff needs to be changed. So you can flash this one and afterwards a mega should work... look at:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=181271#181271


Ok... neat. How would I go about installing samba manually? Does a version of samba exist that is compatible with Broadcom architecture?

And... does this version fix the 5 ghz antenna speed issue? Does the nvram stuff need to be saved as a startup script? I am going to take the plunge today if most of this stuff is fixed.

More questions, questions, questions. Very Happy

_________________
First Network:
Linksys WRT600N V1.1 as Router - DD-WRT v24 mega
Asus WL-330g as AP - Stock Firmware
Linksys WAP54G V3.1 as AP - DD-WRT v24 micro
Linksys WRT54G V4.0 as AP - DD-WRT v24 std

Second Network:
D-Link DIR-655 as Router - Stock Firmware
Goto page Previous  1, 2, 3 ... 13, 14, 15 ... 19, 20, 21  Next Display posts from previous:    Page 14 of 21
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum