Joined: 07 Jun 2006 Posts: 2087 Location: Odessa, Ukraine
Posted: Tue Apr 15, 2008 18:32 Post subject:
Okay, NO the current KILLER V3 will not work with this router, I need to make a new killer for it, the code pattern has change d for this router. _________________ Want JTAG support - Donate a router
or Donate with PayPal !
Joined: 07 Jun 2006 Posts: 2087 Location: Odessa, Ukraine
Posted: Wed Apr 16, 2008 11:02 Post subject:
I will PM it to you, instruction are the same as GV8 and GSv7 only header is different. You will know when you try to upgrade it thru the linksys firmware upgrade page, if it says upgrade failed, then stop. If it says successfull, make sure you wait 2 mins after it reboots or you reboot it.
When it reboots, it then has to write a new CFE to the router and erase the rest of the flash, then you can tftp "micro ONLY"
I really need a backup of that BSP, but I guess later, when soemone has jtag connected I will get one. _________________ Want JTAG support - Donate a router
or Donate with PayPal !
I have a linksys WRT54G v7.2 (s/n CDFK1GC34968) and I'm not able to upgrade the firmware.
I booted in firmware upgrade mode a tried to install vxworkskillerGSv7-v3.bin.
After few seconds a page appear in IE7 with the text "Upgrade Fail".
Do you have a new version of the vxworkskiller?
If so can you send it to me I'll be pleased to test it...
Joined: 07 Jun 2006 Posts: 2087 Location: Odessa, Ukraine
Posted: Sun Apr 20, 2008 12:25 Post subject:
We are working on a new killer, but Eko has to get the board first. Maybe this week. _________________ Want JTAG support - Donate a router
or Donate with PayPal !