Posted: Sun Sep 21, 2025 19:36 Post subject: Airgrid M5 Hp flash report (New Build - 09/20/2025 - r62170)
Router/Version: Ubiquiti Airgrid M5
File/Kernel: Airgrid M5.HP-flashed21.sep.2025-rr62170/Linux 3.18.140-d6 #246353 Sat Sep 20 10:11:02 +07 2025 mips
Previous/Reset: First flesh
Mode/Status: Ap/ Up and running 10h 5min,good
Issues/Errors: can not backup, ssh and telnet access do not work
Last edited by Vercety on Tue Sep 23, 2025 6:28; edited 2 times in total
Yes i could use a trial, but i will see more, looks like use it on free may be as it was from start.I will run more than 24 hours then i will see is it posibile.
Verry big range of channels unlocked from 36-177 ch
Am more worryed about unable to access cli(telnet or ssh)
Bandwidth is limited maximum is 18Mbps or its becouse of old technology.Its not dual its just 5Ghz wifi.
Wifi is ok, but has variables from -70 -64 -50 -48 -45.
Later signal be stabile by the some minutes.Its ok.Wifi is ok on 1 m it gets even -34.Variables now are -55 -56 its ok(The feed is in wood desk for tuf tests).
That is maked for LR wich can that variables be little bit issue.
UI https://i.imgur.com/KntGVUK.png
Wifi channels https://i.imgur.com/5wrZGg9.jpeg
Wifi channels https://i.imgur.com/HdTzjdc.jpeg
Cpu usage is on maximum,and so and memory usage.Device is little heated.
Cpu usage is on 48 percent.
I dont know to flash on board with serial.I cant upgrade all pages airgrid give is register.html.And solution would be cli wich is not.Also tftp can not be done reset button is broken.Its ower. And i dont want to buy licence.
