[teskilatimahsusa87]

Look guys this is very important. I used freshtomato, openwrt before, they better or worse but a working IPTV config, and not too hard to do so. Unlike dd wrt. You tell me read this wiki or what but then I go that wiki, it says enable this from this page, I go there, there is nothing written like they say. Please help. Why would I use dd wrt if can't even configure IPTV? This is too important for us.

I am using Archer C9 v3.0 on dd-wrt. Sometimes it so happens that, wifi and IPTV borks at the same time. They stop working. I don't know why. I checked the wiki, it says disable multicast in security tab, but thing they say is not what it writes there. In Security tab it says "Multicast Communication" under Block Wan Requests. Which is ticked for me. Do I untick it or what?

Also they say something in Wireless section, "optimize multicast traffic" tick this they say, no such thing there.

And also it says change wifi bridge to another like 192.168.x.1 why the hell would I do that? That's probably not neccessary. How do I access my computer from my phone then?

Here is the setup for my IPTV; this works most of the time. Unless sometimes it borks:

[ho1Aetoo]

The IP-TV VLAN is completely isolated.
It is only forwarded from the WAN port to port 1 within the switch.

No traffic from VLAN55 somehow reaches the router.

Your problems cannot have anything to do with WLAN and whatever else.

[Per Yngve Berg]

As the CPU port is not included in vlan55, the Multicast Deamon will not see it.