I am now trying to get the VAP called CasaMikeJak working. I have set the same security key as the Huawei 4G signal and tried to set up the option needed in Setup-networking - I cannot connect to ssid CMJ but I can see that network configutation at the bottom of the screenshot does not have an IP address range assinged to ra1.
Joined: 08 May 2018 Posts: 14223 Location: Texas, USA
Posted: Tue Jun 06, 2023 7:47 Post subject:
Is the multiple DHCP server option not working on the Setup -< Networking tab (at bottom)? The option you're using has mixed results as well. You can screenshot the entire page via webcapture in Microsoft Edge. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
I am now trying to get the VAP called CasaMikeJak working. I have set the same security key as the Huawei 4G signal and tried to set up the option needed in Setup-networking - I cannot connect to ssid CMJ but I can see that network configutation at the bottom of the screenshot does not have an IP address range assinged to ra1.
having trouble attaching full screen copies of dd-wrt pages .... have attached top and bottom of setup services and service managment - DNSmasq infrastructuure setting I have used
last jpeg - hope they are legible - and just spotted typing error in Setup-networking Network Config for br1 ip address and corrected 192.68.2.1/24 to 192.168.2.1/24.
Still no ip address in DHCPD Mult DHCP Servers
just spotted this note in dd-wrt wiki for Multiple WLANS
"
Allow br1 access to br0, the WAN, and any other subnets (required if SPI firewall is on)
iptables -I FORWARD -i br1 -m state --state NEW -j ACCEPT
iptables -I FORWARD -p tcp --tcp-flags SYN,RST SYN -j TCPMSS --clamp-mss-to-pmtu "
I do have SPI firewall enabled in Security tab - there is no mention in the dd-wrt WIKI for repeater bridge of disabling this setting??
Joined: 08 May 2018 Posts: 14223 Location: Texas, USA
Posted: Tue Jun 06, 2023 17:21 Post subject:
Exactly what @ho1Aetoo said, as I was alluding to before in my previous comment. Also, you don't necessarily need the firewall rules unless you expect to access the webUI over wireless, which I do not advise. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
Thanks
Now have ip adress 192.168.2.1/24 but still no connection from wifi devices just get "connection failed" - tried removing security but no effect- dd-wrt syslog attached "apd0 is not associated" - to what ?
Thanks - progress made by fixing wifi channel at both AP and Repeater - device connected and received IP address in correct range but no access to internet - Will pick up tomorrow- thanks to all