ob2s DD-WRT Novice
Joined: 04 Dec 2012 Posts: 16
|
Posted: Wed May 31, 2023 20:21 Post subject: One Hop 1/2 speed Linksys E3000 - advice |
|
Below is the router I use. Works great, I use the syslog feature for managing an alarm system, very handy, however I pay xfinity for 200Mbs, but I can only render 100Mbs. I recently plugged my windows box's ethernet connection to the cable modem and rendered 225Mbps. Then I plugged only this windows box to the E3000 router and the only other E3000 connection was between the WAN port and the cable modem. I can only render 100Mbs. How can I troubleshoot this ? The E3000 has wifi off.
Thanks
PS Upgraded to latest DD-WRT v3.0-r44715 mega (11/03/20) - same 1/2 speed result.
Router Nameddwrt
Router ModelLinksys E3000
Firmware VersionDD-WRT v3.0-r40559 mega (08/06/19)
Kernel VersionLinux 2.6.24.111 #9521 Tue Aug 6 00:35:00 +04 2019 mips
MAC AddressC0:C1:C0:D1:5B:6F
Hostname
WAN Domain Namehsd1.or.comcast.net.
LAN Domain Name
Current TimeWed, 31 May 2023 13:07:26
Uptime2 min
CPU
CPU ModelBroadcom BCM4716 chip rev 1
CPU Cores1
CPU FeaturesMIPS16 DSP
CPU Clock480 MHz
Load Average
43%0.43, 0.25, 0.09 |
|
Alozaros DD-WRT Guru
Joined: 16 Nov 2015 Posts: 6411 Location: UK, London, just across the river..
|
Posted: Wed May 31, 2023 21:00 Post subject: |
|
you seem like a classic case
-first.. see the forum guidelines with helpful pointers about how to research your router, where and what firmware to download, where and how to post and many other helpful tips:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
-than update to a newer build as the one you run is old and not recommended
-last builds here https://download1.dd-wrt.com/dd-wrtv2/downloads/betas/2023/
In general routers have a different classes..and specs..low specs routers cant do much
for better speeds its always recommended better routers...
many posts on your subject...
with 2 words when you update...reset after the update and rebuild your settings manually...
Than try, on basic config page there is a section called Shortcut Forwarding Engine (next to MTU). enable it save and reboot and check your speed again...if this helps...
dont forget to read the guidelines !! _________________ Atheros
TP-Link WR740Nv1 ---DD-WRT 55179 WAP
TP-Link WR1043NDv2 -DD-WRT 55303 Gateway/DoT,Forced DNS,Ad-Block,Firewall,x4VLAN,VPN
TP-Link WR1043NDv2 -Gargoyle OS 1.15.x AP,DNS,QoS,Quotas
Qualcomm-Atheros
Netgear XR500 --DD-WRT 55460 Gateway/DoH,Forced DNS,AP Isolation,4VLAN,Ad-Block,Firewall,Vanilla
Netgear R7800 --DD-WRT 55460 Gateway/DoT,AD-Block,Forced DNS,AP&Net Isolation,x3VLAN,Firewall,Vanilla
Netgear R9000 --DD-WRT 55363 Gateway/DoT,AD-Block,AP Isolation,Firewall,Forced DNS,x2VLAN,Vanilla
Broadcom
Netgear R7000 --DD-WRT 55460 Gateway/SmartDNS/DoH,AD-Block,Firewall,Forced DNS,x3VLAN,VPN
NOT USING 5Ghz ANYWHERE
------------------------------------------------------
Stubby DNS over TLS I DNSCrypt v2 by mac913 |
|