Joined: 09 Feb 2008 Posts: 54 Location: Melbourne, Australia
Posted: Tue Feb 07, 2023 1:13 Post subject: Re: r51576 on Archer C9 V1.0
egc wrote:
eladb wrote:
Router/Version: TP-Link Archer C9 V1.0
Firmware: DD-WRT v3.0-r51576 std (02/04/23)
Kernel: Linux 4.4.302-st28 #8602 SMP Sat Feb 4 04:03:50 +06 2023 armv7l
Previous: DD-WRT v3.0-r44715 std (03/11/20)
Update Method: webflash
Mode/Status: Router/OK
Reset: Yes
Setup Using: 2.4 GHz as STATION BRIDGE
Issues/Errors: Will NOT CONNECT using wl0 as a Station Bridge. Also important, during configuration, after 3 or 4 SAVE's of config, before APPLY SETTINGS, router systematically freezes and needs hard reset.
Coming from such an old build you need a reset to default after upgrading and you have to put settings in manually, never restore from a backup (to a different build).
Attached my personal notes how I setup a station bridge maybe they are useful.
Thanks for those notes...I had already configured exactly as you suggested.
Of course I did a reset, especially since router freezes after too many SAVEs.
I'm connecting to an iPhone hotspot.
r44715 worked perfectly well giving up to 90Mbps throughput.
I just hope I can get a newer version performing just as well.
Dank je wel !
Router/Version: Asus RT-3100
File/Kernel: asus-rt-3100.trx/Linux 4.4.302-st28 #8585 SMP Sun Jan 29 06:03:49 +06 2023 armv7l
Previous/Reset: DD-WRT v3.0-r51530 std (01/29/23)/No
Mode/Status: NAT,CTF;AP 2/5GHz,Mixed Mode,WPA2;Wireguard Client Site-Site;
No DHCP,DNS;
Issues/Errors:
After upgrading to 51576, 5 GHz became unreliable and never showed more than 400 Mbps TX rate (1083 RX Rate). Reverting brought back higher 1083 TX & RX rates. I also noticed disconnects on Android phone with 51576.
Both cat | grep commands returned nothing (mtd0ro is there, just no ccode or regrev). I have been using this router for a number of years with no issues on either the 2.4 or 5 GHz until this releaase and backing off to the indicated prior release has no issues. Note also this router does not support FA, according to the UI but I do have CTF set. While the country settings are for the US, mode and TPC Mitigation are off.