Posted: Sat Feb 04, 2023 17:00 Post subject: New Build - 02/04/2023 - r51576
Welcome to Atheros r51576 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp). 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Router/Version: NetGear r7800 / File/Kernel: 01-29-2023-r51530 / Linux 4.9.337 #1527 SMP Sat Feb 4 03:24:41 +07 2023 armv7l Previous/Reset: 01/29/2023 - r51530 / No Reset Mode/Status: AP / Working but with deficiencies Issues/Errors: 5GHz LED not working but 5GHz Wi-Fi working, Startup Command not working / No errors in log
Rebooted power cycled - same issues
Reloaded previous NVRAM & reboot - same issues
Reloaded r5130 with reset - still no 5GHz LED
Reloaded NVRAM again - same issues 5GHz LED & no startup command run
Manually run startup command - all good except still no 5GHz LED
Other than that, working normally _________________ - a candle loses nothing by lighting another candle
Router/Version: TP-Link WDR4900 V1
File/Kernel: tl-wdr4900-webflash.bin / Linux 4.4.302-st25 #2942 Wed Nov 23 04:45:32 +06 2022 ppc
Previous/Reset: r50931 / yes
Mode/Status: Gateway / bad flash Issues/Errors: yes
Unsuccessful firmware installation. All new versions are broken since r50931
It is better to refrain from installing, having no experience in recovery
Router/Version: TP-Link TL-WR1043ND v4
File/Kernel: factory-to-ddwrt.bin / tplink_wr1043nd-v4.bin / Linux 3.18.140-d6 #162464 Sat Feb 4 07:18:10 +06 2023 mips
Previous/Reset: r51530 / no
Mode/Status: AP wired and wireless / Up and running for 2 hours
Issues/Errors: Nothing significant
Router/Version: TP-Link TL-WR841ND v11
File/Kernel: tl-wr841nd-webflash.bin / Linux 3.18.140-d6 #162448 Sat Feb 4 06:56:58 +06 2023 mips
Previous/Reset: r51530 / no
Mode/Status: AP wired and wireless / Up and running for 2 hours
Issues/Errors: Nothing significant
The fact is that the router connected to the Internet (to the Internet provider). And it reports an error, the orange WAN indicator flashes (the icon in the form of a planet). Internet is working, I just think it's a glitch
Thank you BS and gurus _________________ Atheros
Netgear XR500 Nighthawk - DD-WRT 54545
Tp-Link TL-WDR4900 v1.3 - DD-WRT 53133
TP-Link WR1043ND v4 - DD-WRT 51838
TP-Link WR1043ND v2 - Gargoyle OS 1.13.0
TP-Link WR841ND v11 - DD-WRT 55779
Broadcom
Asus RT-AC87U R - DD-WRT 55819
Asus RT-N66U - DD-WRT 55779
Linksys WRT54GL v1.1 - DD-WRT 54517M
Linksys WRT54GL v1.1 - FreshTomato 2023.4_MIPS_K26
Linksys WRT54GL v1.1 - Gargoyle OS 1.6.2
Linksys EA8500...main gateway
DD-WRT v3.0-r51576 std (02/04/23)
Linux 4.9.337 #1525 SMP Fri Feb 3 14:47:28 +07 2023 armv7l
scp 'firmware.bin' install over r51530
all good -- uptime 16:31
#
Netgear WNDR3700 V4
DD-WRT v3.0-r51576 std (02/04/23)
Linux 3.18.140-d6 #162490 Sat Feb 4 08:19:27 +06 2023 mips
scp 'firmware.bin' install over r51530
all ok -- uptime 17:05
After upgrade, all 6 in my signature became unresponsive over night. Wifi connects, but no internet, LAN, GUI, or SSH access. I've reverted all to the previous build.
Edit: I'm suspecting there was an electrical issue in my neighborhood last night. _________________ Current devices:
XR500 - gateway
5x R7500v2 - AP
OpenMediaVault server for tailscale, SMB, & Emby
Last edited by mwbuss8 on Sun Feb 05, 2023 14:29; edited 1 time in total
Status: Up and running for 4 hours, basic setup as Gateway, static leases, port forwarding DDNS, WOL, 2,4GHz, VAP for IoT, 5Ghz, (Vanilla Firmware, Disabled Airtime), DDNS (Inadyn) to freedns.afraid.org.
On demand governor with minimum 800 MHz.
IPv6 working with PD /56.
Joined: 06 Jun 2006 Posts: 7492 Location: Dresden, Germany
Posted: Mon Feb 06, 2023 13:20 Post subject:
KACTET wrote:
Router/Version: TP-Link WDR4900 V1
File/Kernel: tl-wdr4900-webflash.bin / Linux 4.4.302-st25 #2942 Wed Nov 23 04:45:32 +06 2022 ppc
Previous/Reset: r50931 / yes
Mode/Status: Gateway / bad flash Issues/Errors: yes
Unsuccessful firmware installation. All new versions are broken since r50931
It is better to refrain from installing, having no experience in recovery
Router/Version: TP-Link TL-WR1043ND v4
File/Kernel: factory-to-ddwrt.bin / tplink_wr1043nd-v4.bin / Linux 3.18.140-d6 #162464 Sat Feb 4 07:18:10 +06 2023 mips
Previous/Reset: r51530 / no
Mode/Status: AP wired and wireless / Up and running for 2 hours
Issues/Errors: Nothing significant
Router/Version: TP-Link TL-WR841ND v11
File/Kernel: tl-wr841nd-webflash.bin / Linux 3.18.140-d6 #162448 Sat Feb 4 06:56:58 +06 2023 mips
Previous/Reset: r51530 / no
Mode/Status: AP wired and wireless / Up and running for 2 hours
Issues/Errors: Nothing significant
The fact is that the router connected to the Internet (to the Internet provider). And it reports an error, the orange WAN indicator flashes (the icon in the form of a planet). Internet is working, I just think it's a glitch
Thank you BS and gurus
i checked it this morning with latest version and it worked without any issues on the 4900. i hope you can recover it. its unfortunatly only possible with serial console. to enter you uboot you need also a special key sequence namend "vl" _________________ "So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
Joined: 16 Mar 2019 Posts: 353 Location: Szczecin, Poland EU
Posted: Tue Feb 07, 2023 23:35 Post subject: New Build - 02/04/2023 - r51576
Router/Version: TP-Link TL-WDR3600 v 1.5
Kernel: Linux 3.10.108-d11 #124990 Sat Feb 4 05:14:01 +06 2023 mips
Reset: No
Mode: Internet gateway, WIFI 5GHz AP, dnsmasq server, firewall
Status: Working
Issues: I have some yellow marked events in log, but it's nothing significant
Uptime: ~ 82h
Router working without significant problems. Performance is rather good.