Posted: Sun Jan 15, 2023 7:34 Post subject: New Build - 01/15/2023 - r51306
Welcome to Marvell r51306 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Linksys WRT1900ACS v1
Firmware : DD-WRT v3.0-r51306 std (01/15/23)
Kernel : Linux 4.9.337 #3599 SMP Sun Jan 15 05:27:28 +07 2023 armv7l
Work stable with unbound.
Upgrade via CUI from r51288 without reset.
WiFi on 2.4 & 5GHz stable.
dnsmasq version 2.87, in oisd.nl can be found new smaller files for blocking.
format like local=/xyzw.net/ instead of address=/xyzw.net/#, which saved memory occupied.
here I have a private question, how to use command switch off the WiFi status without restart dnsmasq.
Joined: 12 Dec 2007 Posts: 780 Location: Pittsburgh, PA USA
Posted: Mon Jan 16, 2023 3:18 Post subject:
Router/Version: WRT1900AC v1
File/Kernel: DD-WRT v3.0-r51306 std (01/15/23)
Previous/Reset: DD-WRT v3.0-r51288 std (01/12/23), No reset this time, no config changes
Mode/Status: Gateway (SFE enabled), Access Point, IPV6 (DHCP6 w/ prefix delegation), Entware, DOT via SmartDNS, OpenVPN server, Wireguard Server, Privoxy
Issues/Errors:
Up 22 hours, nperf.com shows expected ISP speeds, both wired and wireless. OpenVPN, Wireguard, DOT, and Privoxy all working as expected.