timw DD-WRT Novice
Joined: 16 Nov 2022 Posts: 1 Location: Berkeley, California, USA
|
Posted: Wed Nov 16, 2022 7:07 Post subject: Missing IBSS in QCA988X firmware? |
|
I wanted to use the DD-WRT version of the QCA988X firmware in a project, but when I replace the standard CT firmware on my linux install with the DD-WRT version, IBSS isn't listed as an interface mode. Is this a bug or am I missing something? It's absolutely exists with the default CT firmware.
I also tried this on an OpenWRT install on a Ubiquiti Rocket 5AC Lite which showed the same issue (in case anyone wants to reproduce this)
Thanks
Tim
Code: | root@OpenWrt:~# iw list
Wiphy phy0
wiphy index: 0
max # scan SSIDs: 16
max scan IEs length: 199 bytes
max # sched scan SSIDs: 0
max # match sets: 0
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Device supports AP-side u-APSD.
Available Antennas: TX 0x3 RX 0x3
Configured Antennas: TX 0x3 RX 0x3
Supported interface modes:
* managed
* AP
* monitor
* mesh point
Band 2:
Capabilities: 0x19ef
(truncated) |
|
|