Any DreyTek Specialists in the house

Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking
Author Message
chrisWi
DD-WRT Novice


Joined: 30 Aug 2022
Posts: 4

PostPosted: Tue Aug 30, 2022 18:19    Post subject: Any DreyTek Specialists in the house Reply with quote
Hi all! At-A-Loss and stumped.

I just bought a DreyTek 2865-lac and have this as my main router (VDSL) however I have a secondary router with VPN (Linksys 3200 dd-wrt). \For the life of me I am 100% stuck, I have searched, read and watched but cannot figure out how to allow the Dreytek router to allow the Linksys dd-wrt VPN router to connect to the DreyTek as a passthrough for VPN?

I had a Tplink prior to the DrayTek and it was simple enough to connect the VPN Linksys dd-wrt via Ethernet and configure, but trying to figure this DreyTek is causing a right old headache.

Should I first try and simply connect lan to lan with ethernet then attempt a passthrough? So many mixed messages on how to configure this router.

Any and all help greatly appreciated.

Thank you.
Sponsor
DWCruiser
DD-WRT User


Joined: 15 Aug 2016
Posts: 223
Location: Melbourne, Australia

PostPosted: Wed Aug 31, 2022 1:13    Post subject: Re: Any DreyTek Specialists in the house Reply with quote
I don't use DrayTek.

But the typical solution would be to use Port-Forwarding (from DrayTex) to allow incoming VPN traffic to reach your Linksys, via Linksys's WAN IP address together with the specific port used in your Linksys' VPN settings.

From a quick search online, for DrayTek, it's called Port Redirection (under NAT heading).

It's assumed here that your Linksys (running DDWRT) is already working fine, with its WAN port connected to a DrayTek's LAN port.

_________________
Life is a journey; travel alone makes it less enjoyable and lonely.
ho1Aetoo
DD-WRT Guru


Joined: 19 Feb 2019
Posts: 2899
Location: Germany

PostPosted: Wed Aug 31, 2022 5:57    Post subject: Reply with quote
Why not just configure the Draytek as "full bridge mode" and use the Draytek as a simple modem?
DWCruiser
DD-WRT User


Joined: 15 Aug 2016
Posts: 223
Location: Melbourne, Australia

PostPosted: Wed Aug 31, 2022 7:16    Post subject: Reply with quote
ho1Aetoo wrote:
Why not just configure the Draytek as "full bridge mode" and use the Draytek as a simple modem?


Your suggestion would certainly be much simpler. Of course, the routing features of the DrayTek would be rendered inoperative in that case.

_________________
Life is a journey; travel alone makes it less enjoyable and lonely.
chrisWi
DD-WRT Novice


Joined: 30 Aug 2022
Posts: 4

PostPosted: Wed Aug 31, 2022 8:37    Post subject: Bridge mode Reply with quote
Indeed bridge mode would be the simpler method, and yes the features of the Draytek would be lost which is what I want to avoid.

The reason for the purchase were for the features themselves so now I have hit a brick wall with a tooth-pick frantically looking where to start.

One of the issues I have found is there are several methods, yet conflicting ones.
egc
DD-WRT Guru


Joined: 18 Mar 2014
Posts: 12812
Location: Netherlands

PostPosted: Wed Aug 31, 2022 9:03    Post subject: Reply with quote
Are you talking about setting up an OpenVPN client or on OpenVPN server?
_________________
Routers:Netgear R7000, R6400v1, R6400v2, EA6900 (XvortexCFE), E2000, E1200v1, WRT54GS v1.
Install guide R6400v2, R6700v3,XR300:https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=316399
Install guide R7800/XR500: https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=320614
Forum Guide Lines (important read):https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
chrisWi
DD-WRT Novice


Joined: 30 Aug 2022
Posts: 4

PostPosted: Wed Aug 31, 2022 9:14    Post subject: Reply with quote
Thanks DWCruiser,

Yes, all is running on the Linksys dd-wrt and VPN is also up.

What I have done is run ethernet from DreyTek lan to lan port on the Linksys.

I did try the DreyTek lan port to Linksys Wan port but did not get anywhere so I assumed I should carry on with lan to lan as this was the way I connected with the TPlink which Ive just changed.

Its all a great trial.
chrisWi
DD-WRT Novice


Joined: 30 Aug 2022
Posts: 4

PostPosted: Wed Aug 31, 2022 9:24    Post subject: Reply with quote
Hi egc,

No, what I have is my main DreyTek router and a second router which is the linksys dd-wrt that has the VPN installed.

The issue I'm having is that despite running a ethernet from the draytek to the linksys dd-wrt vpn, the draytek is not allowing the linksys through, thus, I am unable to connect devices to the vpn behind the draytek.

Gosh, sounds like a tongue twister.
egc
DD-WRT Guru


Joined: 18 Mar 2014
Posts: 12812
Location: Netherlands

PostPosted: Wed Aug 31, 2022 10:52    Post subject: Reply with quote
The Question was if this is an OpenVPN server or an OpenVPN client

An OpenVPN server is to connect from outside to your home network e.g. when you are on the road and want to connect to your home

An OpenVPN client is usually to a commercial provider and is used to safely browse the web.

If you are referring to an OpenVPN client, that should work right out of the box, your Draytek has nothing to do with that.

Some prerequisites:
-The Linksys is in default gateway mode and connected with its WAN port to the LAN of the Draytek.
-The clients are connected to the Linksys (for testing preferably with LAN).
-You are running a recent build, latest is 50012

First check if you have normal internet access before setting up a VPN.

If you do not have internet access then reset to defaults and check again, if you still not have internet access then change the Local IP address of the Linksys (on Setup page) from 192.168.1.1 to 192.168.22.1

If you have internet then importing the OpenVPN configuration from your provider usually is enough to get going.

See the OpenVPN Client Setup guide: https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=327398

P.S. I moved this thread to the more appropriate Advanced Networking forum

_________________
Routers:Netgear R7000, R6400v1, R6400v2, EA6900 (XvortexCFE), E2000, E1200v1, WRT54GS v1.
Install guide R6400v2, R6700v3,XR300:https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=316399
Install guide R7800/XR500: https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=320614
Forum Guide Lines (important read):https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum