Posted: Fri Aug 26, 2022 12:03 Post subject: c9 port bonding
hi everyone.
i am trying to separate one of the ports network from networking -- port setup.
ive unbridged it assigned another dchp to that but it doesn't want to does it.
ive already managed to done that with creating virtual ap and separate its network with same way.
i don't understand why this is not working.
can any one help me pls?
thnx
port2.jpg
Description:
2
Filesize:
69.73 KB
Viewed:
1295 Time(s)
port1.jpg
Description:
1
Filesize:
128.77 KB
Viewed:
1295 Time(s)
Last edited by article15 on Tue Aug 30, 2022 9:46; edited 1 time in total
hi,
i am on DD-WRT v3.0-r49866 std with archer c9 v1
i ve created new vlan for port 4 from switch config, then unbridged it from network config and added multiple dhcp. but right now it doesnt wantto serve ip.
also ive created virtual ap for 2.4ghz channel. with same steps it does serv ip.
dunno what is wrong.
any suggests?
thnx
Are you trying to use a separate VLAN for your guest network? Doesn't this require a new bridge to be added (br1) and VAP / VLAN assigned to it? Are you also trying to separate one of the ethernet ports to this VLAN as well? It seems unclear as to what the scope and goal is here. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
Joined: 18 Mar 2014 Posts: 12917 Location: Netherlands
Posted: Tue Aug 30, 2022 16:15 Post subject:
I just did a quick test and it works as advertised.
router EA6900, build 49934
On Switch Config Tab I made VLAN 4 and put port 2 on VLAN 4
Apply and after a couple of minutes on Networking Page I could see VLAN 4, unbridged it put it on its own subnet.
Apply, after a few minutes made a DHCP server on that same page Apply, and after a few minutes a reboot and my PC attached to Port two was on its own subnet
i am not really sure too. i am able to done this things on pfsense without any issue.
still not sure but i guess but something wrong with archer c9 and ddwrt switch and port bondings.
as the same way if ive create virtual ap to 2ghz ten unbridged it with its own subnet then everything's works fine. also i am fed-up that i had to reboot router after every movement otherwise it doesn't care about my changes
Try physical ethernet port 1. Port order may be backwards between the webUI and the physical ports. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio