[article15]

hi everyone.
i am trying to separate one of the ports network from networking -- port setup.
ive unbridged it assigned another dchp to that but it doesn't want to does it.
ive already managed to done that with creating virtual ap and separate its network with same way.
i don't understand why this is not working.
can any one help me pls?
thnx

[egc]

We can give better support if you state router model and build number.

See the forum guidelines with helpful pointers about how to research your router, where and what firmware to download, where and how to post and many other helpful tips:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087

[article15]

hi,
i am on DD-WRT v3.0-r49866 std with archer c9 v1
i ve created new vlan for port 4 from switch config, then unbridged it from network config and added multiple dhcp. but right now it doesnt wantto serve ip.
also ive created virtual ap for 2.4ghz channel. with same steps it does serv ip.
dunno what is wrong.
any suggests?
thnx

[egc]

From CLI (telnet/Putty) try:
stopservice dnsmasq && startservice dnsmasq

Or reboot the router

[egc]

As this is about an Archer C9, I moved this to the Broadcom forum

@article15 You might edit the title for the thread as it has nothing to do with port bonding

[article15]

[dale_gribble39]

Are you trying to use a separate VLAN for your guest network? Doesn't this require a new bridge to be added (br1) and VAP / VLAN assigned to it? Are you also trying to separate one of the ethernet ports to this VLAN as well? It seems unclear as to what the scope and goal is here.

[egc]

I just did a quick test and it works as advertised.

router EA6900, build 49934

On Switch Config Tab I made VLAN 4 and put port 2 on VLAN 4

Apply and after a couple of minutes on Networking Page I could see VLAN 4, unbridged it put it on its own subnet.

Apply, after a few minutes made a DHCP server on that same page Apply, and after a few minutes a reboot and my PC attached to Port two was on its own subnet

So not sure what is going on your side but for me it is working

[article15]

i am not really sure too. i am able to done this things on pfsense without any issue.
still not sure but i guess but something wrong with archer c9 and ddwrt switch and port bondings.
as the same way if ive create virtual ap to 2ghz ten unbridged it with its own subnet then everything's works fine. also i am fed-up that i had to reboot router after every movement otherwise it doesn't care about my changes

[egc]

You only have to reboot when you are done.

But the Archer should be a fairly standard Broadcom Northstar router but with low flash ram.

But who knows which corners TP link has cut, not my favourite brand.

[dale_gribble39]

Try physical ethernet port 1. Port order may be backwards between the webUI and the physical ports.