The screenshot is to help me find the Host Name setting? If is it, I'm sure, don't have, I'm know this is a very common and basic setting, but this one don't have on Web UI, I know this is a shame, but I'm sure, this is why I want to edit this setting on exported config and re-import it.
Under Administration - > Server Name, you can set that to manual and that should be the hostname. It doesn't cover it in the user guide, but I stepped through the simulator on the vendor's website. It's for the V3, but I doubt they changed the webUI that much. Only one way to find out!
There is also a WISP mode covered on the vendor's website. If there is an nvram variable in the config file, there is a place in the webUI to change it on stock firmware most of the time. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
They changed! My router UI is EXACTLY like on pdf of version 2 of the link I posted, don't have Server Name or Service Name, I'm sure, I searched for this setting in all Web UI pages, don't have on Web UI, sorry, I'm not specialist on routers or flashing routers, but I'm not quite ignorant, I know a little bit, :D if it was easy as open the Web UI and set it, why I should be here 3 weeks trying some help? :D
I cannot find a firmware image for this specific router anywhere on the internet, so there's only two options: Figure out how to manipulate that @ number sequence for necessary changes, or figure out how to connect serial console and crack into it. Without device in hand, this is where my "help" ends. Happy Hunting; Good luck. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio