[kernel-panic69]

And that is the generic mac80211 driver that all wireless drivers in DD-WRT rely on, if I am not mistaken.

[kris18890]

I found PBPhoto's settings documented in the 10/20/2021 - r47581 build thread, particularly the ones about "wireless network mode" & sensitivity rage" successful

[blkt]

New Build - 12/02/2021 - r47720

New Build - 12/04/2021 - r47745

[STEVEG2088]

I have always had stock on partition 1 and ddwrt (now 47581) on partition 2. I have also always reset and manually entered config from scratch. However, this is a pain each time.

Now, as I wish use each partition as a toggle solution, am I right in assuming :

If I replace stock with say 47720:

1. Can I simply flash from ddwrt (on partition 2) using the factory to ddwrt bin file (presuming) ?

2. I would not need to reset config values as my understanding is that both partitions share the same nvram ?

Thanks in advance for your help

[SurprisedItWorks]

The factory-to-ddwrt file is only for flashing from the stock firmware. If you are doing the flashing from an existing dd-wrt partition, use the ..._webflash.bin file. And yes, you should be able to leave the configuration as-is.

[sjdwrt]

I am an Apple household and stuck at r44048 and have been following the posts on newer versions being stable. I tried r47692 as @pbphoto mentioned it worked really well for him. But though much better after a few hours iPhones started dropping connections. So then I switched to r47745 and for the last 48 hours I have had no connection issues with iPhones or iPads. So for now it appears to me at least that r47745 is gold for me! I did not change any settings from r44048 and no hardware reset - just regular firmware update on the existing partition.

[Prsa01]

[sjdwrt]

Good to know - just hoping I do not ever have to go back to r44048.

[pbphoto]

I've been on 47822 the last 3 days - fantastic.

[greatmoo27]

Router: Linksys 1900ACSV2
Firmware: R47822

Finally made the jump over to the latest firmware 47822 after a year plus on 44048 due to issues with Apple hardware. I followed the guide of resetting NVRAM and updating both partitions to 47822 with factory reset. I had to manual input back all my previous settings (I had screenshot all the important pages).

I can safely say the latest firmware works on Apple products again! iPhone, iPad, iMac, Macbook (all updated to the latest firmware)

Thanks all for testing and really appreciate the community feedback!

[the-joker]

Thanks for latest reports, will mark this as a tentative SOLVED.

[blkt]

This has been solved for two weeks, since r47720, nice to have user feedback though.

Edit: New Build - 07/22/2022 - r49544

[emanon]

I am ready to upgrade from 44048 to 47822. However, I'm not sure of any special steps or special configurations I must do. Can someone provide me with this information? When I read this thread searching for the information, my not-so-smart azz gets confused. Thanks!!!

[the-joker]

@emanon

First you should get human readable backup of your current nvram settings via terminallike so;

[blkt]