Posted: Thu May 20, 2021 8:44 Post subject: New Build - 05/20/2021 - r46716
[WARNING]: This thread is only for feedback on this beta release for developers and the community's benefit.
DO NOT flash this beta release unless you understand the risks involved and device specificrecovery methods.
Avoid discussions! Create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues:
• Show us your findings with steps to reproduce, configuration, output, logs and important information below!
Important:
• For issues provide applicable info: 'dmesg', 'cat /tmp/var/log/messages', syslog, klog, serial, strace, tcpdump, wireshark etc.
• Any firewall NAT or WAN issues, show output: 'iptables -vnL', 'iptables -t nat -vnL', 'iptables -t mangle -vnL' and /tmp/.ipt file.
• Search SVN tickets & discuss in forum before opening. Before reporting: reset & manually set up, not restore from a backup.
• Please include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) & relevant configuration information.
Netgear WNDR3700 V4
DD-WRT v3.0-r46716 std (05/20/21)
Linux 3.18.140-d6 #116031 Thu May 20 09:41:28 +07 2021 mips
GUI install over r46690
up 11:09 all worky ok
#
Linksys EA8500
DD-WRT v3.0-r46716 std (05/20/21)
Linux 4.9.268 #188 SMP Thu May 20 05:38:41 +07 2021 armv7l
GUI install over r46690
up 11:05 all ok
Joined: 17 Jan 2018 Posts: 64 Location: Georgia, USA
Posted: Thu May 20, 2021 19:19 Post subject:
DD-WRT v3.0-r46716 std (05/20/21) working very well for me as access point on my r7800. Up 4.5 hours after GUI update without reset. No noted problems with my setup.
Edit: Up 21 hours and working great for my setup. _________________ R7800 r53339 std (08/01/23)
Private network on bridge br0 = eth1 (vlan 1) + wlan0 + wlan1.
Guest network on bridge br1 = eth1.4 (vlan 4) + VAPs (wlan0.1 + wlan1.1) for IOT devices
(Roku's, Amazon Echos, smart switches, etc.) and guest.
Noob still finding my way.
swconfig dev switch0 set enable_vlan 1
swconfig dev switch0 vlan 1 set ports "1 2 6"
swconfig dev switch0 vlan 4 set ports "3 4 6t"
swconfig dev switch0 set apply
vconfig add eth1 4
brctl addif br1 eth1.4
ifconfig eth1.4 up
Last edited by sweatbee on Fri May 21, 2021 11:44; edited 1 time in total
Netgear R7500v2
DD-WRT v3.0-r46716 std (05/20/21)
Linux 4.9.268 #189 SMP Thu May 20 05:47:26 +07 2021 armv7l
CLI update over 46316 (Had 30 days uptime as WDS Sta )
No Reset
)
