Posted: Fri Feb 18, 2022 18:24 Post subject: ISP setup with PPPOE and VLAN 802.1p R9000
I've followed your suggestion and bought a R9000 instead or Archer C7. I've to re-create similar ISP config to get on internet.
Can someone help me ?
R9000 is runng dd-wrt 48393
Italian ISP config requirements :
PPPOE with VLAN 835 for Internet and VLAN 836 for Voip and all with IEEE 802.1p
MTU will be set to 1492, NAT will be enable and encapsulation will be LLC.
The ISP provide fiber cable with SFP , I've connected through tp-link media converter that convert FC to RJ45.
Joined: 08 May 2018 Posts: 14244 Location: Texas, USA
Posted: Fri Feb 18, 2022 18:40 Post subject:
bordir wrote:
I also understood that my actual router is a low cost router, so if you have any suggestion about a mid level router to buy for running DD-WRT , I will follow your guidelines.
The only direction you can go from here is R7800/XR450/XR500, maybe an R7500v2. But yours is not a "low-end" TP-Link as it has 128MB of RAM and is not a TL-WR1043* series IMO. https://deviwiki.com/wiki/TP-LINK_Archer_C7_v5.x
bordir wrote:
Last question is : this configuration cannot be done all through web interface ?
Joined: 08 May 2018 Posts: 14244 Location: Texas, USA
Posted: Fri Feb 18, 2022 22:31 Post subject:
Sorry, I guess I missed that there were already two pages going on this thread when I commented; you've already started a new thread, so no further discussion in this one should be required. Also, I have already stated what routers I would recommend in this case. I won't recommend an R9000 or XR700. Good luck. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net