Posted: Fri May 14, 2021 14:04 Post subject: gpio enable/disable not working. Archer c7
Hi there,
Trying to use gpio and LEDs don't respond to enable/disable.
gpio poll DOES work when checking switch position.
Read somewhere that Atheros chipsets require a special driver, but /proc/gpio is there and as i said, the poll function works. Yet the enable/disable doesn't, at least when it comes to LEDs.
Do I need to do something first to "disconnect" an LED from its normal function controlled by the firmware?
Router is Archer C7 V2.0
Firmware: DD-WRT v3.0-r37305 std (10/10/18)
Any help is appreciated.
Thank you!
Yanko