jhaverbs DD-WRT Novice
Joined: 31 Dec 2008 Posts: 24
|
Posted: Sun Apr 25, 2021 8:00 Post subject: R8000 wifi speeds with firmware 46329 standard build |
|
I have 2 netgear r8000 routers, both with build 46329. The AP router is connected to internet through netgear cable modem. I have another r8000 in client mode with same firmware. It is on a different subnet. I have client setup on wl0. wl2 is disabled. wl1 at 2.4 ghz is AP.
I get good wifi transfer speed from AP to client router, about 150-200 mbps. But the other way, transferring data from client router to AP is only 1/4 of that, around 40-50 mbps.
Is that expected? Or do I have to adjust wifi settings? I have left all wifi parameters at default. Client is connected to AP router with wl0 channels 161 and 155. I have one devices connected to AP mode of wl1, 2.6 ghz radio on channel 11, that is getting internet through the bridge on wl0.
I have tried several build from 2019, but they all have the same issue. I appreciate any suggestions.
Note: I do not see any Sensitivity Range (ACK Timing)settings on the wireless settings page. Is that missing for MIMO routers or I have a bad firmware flash? |
|