Still random wifi problems with this release. By the way I have isolated an issue that occours only with my iPad and my wife's MacBook Pro (my old MacBook Air seems to be ok). Both iPad and MBP sometimes aren't able to make new session: traffic flowing for an open application continues to flow, but if I try to open other sessions on the same host it is not possible. For example, my wife was in a Zoom call and tryed to open a gmail page: the gmail page can't connect (with no errors, only indefinite wait) while the Zoom call was avtive and working. We need to disconnect-reconnet wifi to come back everything working. I noticed this line repeated many times in the system log:
I noticed the same with iPad, often I need to on/off wifi to load YouTube content, and I get the same rows on the system log with iPad HW address. Other hosts of the network does not do the same.
I know this is an old build, but I did have an issue getting to the GUI management after being up for a long time, you just have to turn off and turn on the wifi on your client device so that it will let you in. _________________ Router: Linksys WRT3200ACM WLAN0 and 1 have same SSID
88W8964 802.11ac WLAN0 Mode AP VHT80 80MHz Mixed Mode Channel and Extension Channel Auto Extension LL-6
88W8964 802.11ac WLAN1 Mode AP 20 MHz Mixed Mode Channel Auto
SD8887 802.11ac disabled but visible on GUI and CLI
TX Power 18 dBm
Antenna Gain 0 dBi
U-APSD (Automatic Power Save)Enabled
Protection Mode None
RTS Threshold Disabled
Short Preamble Disabled
Short GI Enabled
Single User Beamforming Enabled
Multi User Beamforming Enabled
AP Isolation Disabled
Beacon Interval 100
DTIM Interval 2
WMM Support Enabled
Radar Detection Disabled
ScanList default
Sensitivity Range (ACK Timing) 500 (Default: 500 meters)
Max Associated Clients 256 (Default: 256 Clients)
Minimum Signal for authenticate -128
Minimum Signal for connection -128
Poll Time for signal lookup 10
Amount of allowed low signals 3
Wireless security is WPA2 Personal CCMP-128 only
QAM256 is on