Joined: 08 May 2018 Posts: 14221 Location: Texas, USA
Posted: Thu Feb 11, 2021 15:30 Post subject: New Build - 02/11/2021 - r45735
[WARNING]: This thread is only for feedback on this beta release for developers and the community's benefit.
DO NOT flash this beta release unless you understand the risks involved and device specific recovery methods.
Avoid discussions! Create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues:
• There may be remaining issues for Samba.
Important:
• For issues provide applicable info: 'dmesg', 'cat /tmp/var/log/messages', syslog, klog, serial, strace, tcpdump, wireshark etc.
• Any firewall NAT or WAN issues, show output: 'iptables -vnL', 'iptables -t nat -vnL', 'iptables -t mangle -vnL' and /tmp/.ipt file.
• Search SVN tickets & discuss in forum before opening. Before reporting: reset & manually set up, not restore from a backup.
• Please include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) & relevant configuration information.
I am a first time dd-wrt user, so apologies in advance for any dumb questions.
I have a Netgear AC2400 that is compatible with the R6800, and just got this build installed and up and running!
Is there a way to control (turn off) the lights on the router? I've seen other posts about this, but wasn't sure if asking here for the specific build would help.
Also, since this is a New Build, how many more updates should I expect to keep an eye out for?
Joined: 14 Sep 2019 Posts: 301 Location: Maine, USA
Posted: Fri Feb 12, 2021 11:39 Post subject:
DCSooner27 wrote:
I am a first time dd-wrt user, so apologies in advance for any dumb questions.
I have a Netgear AC2400 that is compatible with the R6800, and just got this build installed and up and running!
Is there a way to control (turn off) the lights on the router? I've seen other posts about this, but wasn't sure if asking here for the specific build would help.
Also, since this is a New Build, how many more updates should I expect to keep an eye out for?
Congratulations on your install.
This thread is just for reporting feedback on this specific build, which you did. Any other questions should be asked in the router specific thread.