Posted: Tue Jan 19, 2021 20:25 Post subject: New Build - 01/19/2021 - r45493
[WARNING]: This thread is only for feedback on this beta release for developers and the community's benefit.
DO NOT flash this beta release unless you understand the risks involved and specific device recovery methods.
Avoid discussions! Create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues:
• There may be remaining issues for Samba (for example NTFS).
Important:
• For issues provide applicable info: 'dmesg', 'cat /tmp/var/log/messages', syslog, klog, serial, strace, tcpdump, wireshark etc.
• Any firewall NAT or WAN issues, show output: 'iptables -vnL', 'iptables -t nat -vnL', 'iptables -t mangle -vnL' and /tmp/.ipt file.
• Search SVN tickets & discuss in forum before opening. Before reporting: reset & manually set up, not restore from a backup.
• Please include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) & relevant configuration information.
Router Model / Version: Dlink DIR-882 A1
File: dlink-dir882-a1-webflash.bin
Firmware: DD-WRT v3.0-r45493 std (01/19/21)
Previous: DD-WRT v44715
Reset: YES
Mode: AP
Uptime: ~ 1 Days
Status: working
Services: Openvpn client, DLNA, SAMBA, PPPOE
Issues / Errors: after changing some settings (TurboQAM activation, configuring openVPN client) router won't reboot (loop reboot) until i switch it off then on. sometimes even switching on/off won't work on the first try, i flashed it back to 44715 as soon as i could switch on the router afer many tries. With regard to openvpn client, it didn't work right after configuration so i tried to reboot but i had the issues described earlier. So this version is unfortunately unusable for me, too bad as it seemed to slightly improve throughput (i did some testing with basic setting at early stages of firmware upgrade)/
Last edited by Milax on Fri Jan 22, 2021 18:29; edited 1 time in total
