[ajotaEME]

So, I tried following this https://wiki.dd-wrt.com/wiki/index.php/Repeater_Bridge as well and, got to the very same point as Shandleyman where I cannot see my Repeater Bridge SSID in the list of available wireless networks. Unlike Shandleyman, no matter how much time I wait before plugging the Router back in, I still do not see any additional SSID. Furthermore, I cannot even validate into the Repeater Bridge through Ethernet Ports (not even a valid IP).

Hoping to hear from all of you. Thanks!

P.S. My Main Router's IP is 192.168.0.1 so, the only deviation I made on the Setup / Basic Setup was:
IP Address: 192.168.0.100
Mask: 255.255.255.0
Gateway: 192.168.0.1
DHCP Server: Disable
Local DNS: 192.168.0.1

P.P.S. Firmware dd-wrt.v24-44715_NEWD-2_K2.6_mini-e1200v1

[egc]

I have split your post, reviving a very old thread is not recommended.

The wiki states that K2.6 builds are broking for Repeater bridge, I do not use K2.6 build but perhaps you can step up to a K3 build ?

To get the best out of DDWRT and the forum read the forum guidelines with helpful pointers:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
If you have not already read them, please do !