Author
Message
Varos DD-WRT Novice Joined: 10 Dec 2020 Posts: 2
Posted: Thu Dec 10, 2020 20:25 Post subject: Linksys WRT160Nv3 EoIP
I have a Linksys WRT160Nv3
With firmware DD-WRT v3.0-r44863 mini (11/24/20)
I would like to run EoIP over PPTP.
I was able to set up PPTP between the two routers and everything works fine.
Proceed to the next step and ran into problems.
DD-WRT I cannot start EoIP. Does anyone know why?
Description:
Filesize:
16.71 KB
Viewed:
564 Time(s)
Description:
Filesize:
50.84 KB
Viewed:
564 Time(s)
Back to top
Sponsor
egc DD-WRT Guru Joined: 18 Mar 2014 Posts: 12908 Location: Netherlands
Back to top
Varos DD-WRT Novice Joined: 10 Dec 2020 Posts: 2
Posted: Fri Dec 11, 2020 7:35 Post subject:
egc wrote: Maybe just not for routers with only 4 MB flash ram?
Are you sure this is the case?
I thought that if there is not enough memory, then the functionality is cut off.
But the firmware has this tab. Therefore, I think that it should work.
Back to top
egc DD-WRT Guru Joined: 18 Mar 2014 Posts: 12908 Location: Netherlands
Posted: Fri Dec 11, 2020 10:23 Post subject:
Yes but maybe only for Mikrotik, besides Mikrotik I have "WireGuard" and "RFC 3378 Ethernet over IP" as options to choose from
_________________ Routers:Netgear R7000, R6400v1, R6400v2, EA6900 (XvortexCFE), E2000, E1200v1, WRT54GS v1.
Install guide R6400v2, R6700v3,XR300:https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=316399
Install guide R7800/XR500: https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=320614
Forum Guide Lines (important read): https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
Back to top