trying to upgrade firmware dir-882 to dd wrt fails each time

Post new topic   Reply to topic    DD-WRT Forum Index -> Ralink SoC based Hardware
Author Message
ogormask
DD-WRT Novice


Joined: 23 Aug 2014
Posts: 1

PostPosted: Sun Sep 22, 2019 19:18    Post subject: trying to upgrade firmware dir-882 to dd wrt fails each time Reply with quote
dir-882 upgraded stock firmware to 1.2

trying to change firmware to dd wrt but it fails each time. I have tried several versions but each time it fails. not really sure why its not working. thanks!
Sponsor
kernel-panic69
DD-WRT Guru


Joined: 08 May 2018
Posts: 14102
Location: Texas, USA

PostPosted: Sun Sep 22, 2019 19:26    Post subject: Reply with quote
Wrong forum. That's a MediaTek device, which is part of the Ralink forum.

https://wikidevi.com/wiki/D-Link_DIR-882_rev_A1

https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=310590&p=1095050

https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=319538
Malachi
DD-WRT Guru


Joined: 17 Jul 2012
Posts: 7209
Location: Columbus, Ohio

PostPosted: Sun Sep 22, 2019 22:03    Post subject: Reply with quote
I moved it.
You may have to flash to an older stick firmware using the recovery page. Search for my thread in this forum. You’ll need to download a version of the firmware that is unencrypted.

_________________
I am far from a guru, I'm barely a novice.
Malachi
DD-WRT Guru


Joined: 17 Jul 2012
Posts: 7209
Location: Columbus, Ohio

PostPosted: Sun Sep 22, 2019 22:04    Post subject: Reply with quote
Here is the thread. https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=320252
_________________
I am far from a guru, I'm barely a novice.
casualtester
DD-WRT User


Joined: 13 Dec 2015
Posts: 319

PostPosted: Tue Sep 24, 2019 12:01    Post subject: Reply with quote
ogormask,
Before attempting to switch to dd-wrt firmware,
Suggest you read the feedbacks of the various dd-wrt releases, then decide.
mono
DD-WRT Novice


Joined: 09 Dec 2006
Posts: 31

PostPosted: Thu Nov 26, 2020 18:30    Post subject: Reply with quote
I just went through this with DIR-882 A1, which shipped with rev 1.3 D-Link firmware. There is still old info out there which gives directions that only work for earlier firmware.

As others mentioned, any D-Link firmware (after rev 1.1) wants an encrypted firmware for a webflash, so will need booted to recovery mode to switch to DD-WRT from stock D-Link firmware after rev 1.1

I had seen conflicting info that Firefox was the browser to use, tried an older v54 FF (since people obviously could not have been using the current FF version back when the guides were written) and that failed, it timed out within seconds, with no progress meter.

Next I tried IE11 which worked. I could tell right away it was getting further along because I saw the % progress meter increment upwards. I was in disbelief that it would take as long as 3-5 minutes but that's how long it took.

SO, with the newest (as of today rev 1.3) D-Link firmware, the condensed upgrade for me was:

- Hold in reset button for 10 seconds while powering on. The power button is fine to use, no need to pull and replug the power cable. There was no need to have it turned on first then hold in the reset button in while powering off. Brand new out of the box, just hold in the reset button for 10 seconds when powering on.

- Ethernet connect lan port direct to computer with a static 192.168.0.2 IP addr set.

- Use IE11 to access the recovery console on 192.168.0.1 and upload the DD-WRT factory-to-ddwrt.bin. You will see a % upload bar incrementing if this is working.

- Wait till finished (~ 5 min, it will state successful) then change computer IP to DHCP, then computer should receive a 192.168.1.1** something IP assignment, then you can access 192.168.1.1 for router DD-WRT GUI. You do not need to keep using IE once this far along.


Last edited by mono on Thu Nov 26, 2020 23:52; edited 2 times in total
Krzat
DD-WRT Novice


Joined: 11 Oct 2020
Posts: 9

PostPosted: Thu Nov 26, 2020 23:03    Post subject: Reply with quote
Dir 882 dont makes things easy. If you tame this beast You will know some about dd-wrt.
Google, search forum then ask. Fun, learn, pain.
Here you have some hints:
-Flashing,
https://sushantbhosale.com/install-dd-wrt-d-link-dir-882/
-Vlan, vap,(GUI wont work in most cases)
https://forum.dd-wrt.com/phpBB2/viewtopic.php?p=1207943#1207943
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Ralink SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum