Aruba RAP-2WG.

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware
Author Message
umtsmen
DD-WRT Novice


Joined: 12 Dec 2006
Posts: 17

PostPosted: Thu Aug 20, 2020 16:30    Post subject: Aruba RAP-2WG. Reply with quote
Hello to all
I have this small unit and I'm wondering if DD-WRT can be loaded.

Stock picture here

Looks like an old FONERA unit and I'm sure something can be done.

FCC ID
Q9DRAP2WG

https://fccid.io/Q9DRAP2WG


I'm able to access the unit via serial port and this is the output



APBoot 1.5.22 (build 21475)
Built: 2009-06-04 11:33:22 (with gcc 3.3.1)

CPU: AR2317 MIPS-32 at 184 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Chuck, Local Bus at 92 MHz
DRAM: 32 MB
POST: passed
FLASH: 8 MB
Net: en0 lo0

Hit <Enter> to stop autoboot: 0
Loading FLASH image @ 0xa8080000... not present
Loading FLASH image @ 0xa83f0000...
Verifying checksum...
Image is signed; FIPS signature check
Policy Cert OK
Signer Cert OK
RSA signature verified.

Booting image...
..............................

Aruba Networks
ArubaOS Version 5.0.0.0 (build 23711 / label #23711)
Built by p4build@cartman on 2010-03-22 at 12:33:07 PDT (gcc version 3.4.3)
BOARD - Chuck
CPU frequency 184.00 MHz
Using 92.000 MHz high precision timer. cycles_per_jiffy=184000
Memory: 26080k/32768k available (1996k kernel code, 6672k reserved, 428k data, 2592k init, 0k highmem)
available.
detected lzma initramfs
initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=13437440
LZMA initramfs by Ming-Ching Tiew <mctiew@yahoo.com> ..............................................................................................................................................................................................................
wdt: registered with refresh
Enabling Watchdog
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
physmap flash device: 400000 at 1fc00000
MTD driver for SPI flash.
spiflash: Probing for Serial flash ...
spiflash: Found SPI serial Flash.
8388608: size

Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT
Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT
Starting Kernel DES KAT ...Completed Kernel DES KAT
Starting Kernel AES KAT ...Completed Kernel AES KAT

No panic info available
ethsw: Atheros AR2313: 00:24:6c:c2:58:8d, irq 4
Ethernet port 1 mode: active-standby
Ethernet Channel Bonding Driver: v3.0.1 (January 9, 2006)
bonding: bond0: enslaving eth0 as a backup interface with a down link.
bonding: bond0: enslaving eth1 as a backup interface with a down link.
AP xml model 36, num_radios 1 (jiffies 6683)
init_asap_mod: installation:0
radio 0: band 0 ant 0 max_ssid 8
ethernet_device_event: dev eth0 is register
ethernet_device_event: dev eth0 is up
asap_gre_init: ADDED GRE protocol c0113510
setting bond0 as bridge child
setting gre0 as split child
USB not provisioned
Starting watchdog process...
Starting webserver and dhcp/dns server
bonding: bond0: releasing backup interface eth1
Powering port down briefly
mii: 0x3100
mii_op: phy_id is 4
New value @ 0x0 is 0x3100
Powering port up now
mii_op: phy_id is 4
New value @ 0x0 is 0x800
Waiting for uplink to be ready.......................^@▒^_.^@▒▒▒▒..................


.ifconfig
..~ #
~ #
~ # ifconfig
bond0 Link encap:Ethernet HWaddr 00:24:6C:C2:58:8D
UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

eth0 Link encap:Ethernet HWaddr 00:24:6C:C2:58:8D
UP BROADCAST NOARP SLAVE MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

eth1 Link encap:Ethernet HWaddr 00:24:6C:C2:58:8E
inet addr:192.168.11.1 Bcast:192.168.11.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

ethsw Link encap:Ethernet HWaddr 00:24:6C:C2:58:8D
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:4 Base address:0x1000

gre0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
UP RUNNING MTU:0 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)



if I press enter during the boot, these are the options


APBoot 1.5.22 (build 21475)
Built: 2009-06-04 11:33:22 (with gcc 3.3.1)

CPU: AR2317 MIPS-32 at 184 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Chuck, Local Bus at 92 MHz
DRAM: 32 MB
POST: passed
FLASH: 8 MB
Net: en0 lo0

Hit <Enter> to stop autoboot: 0
apboot>
apboot>
apboot> help
boot - run bootcmd or boot AP image or elf file or from flash
cd - cfg register display
cw - cfg register write
dhcp - invoke DHCP client to obtain IP/boot params
eloop - loopback received ethernet frames
flash - FLASH sub-system
go - start application at address 'addr'
help - print online help
mc - memory copy
md - memory display
mii - MII sub-system
mtest - simple RAM test
netstat - net statistics
mw - memory write
ping - ping net host
printenv - env display
purgeenv - purge env
regs - display various regs
reset - reset processor
run - run commands in an environment variable
saveenv - save environment variables to persistent storage
setenv - set variable in env
tftpboot - boot via tftp
tlb - dump TLB
version - print monitor version
wdog - stop refreshing watchdog timer
apboot>


Thank you for now
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum