When setting up the vap on router Netgear r6250 with build 40270M, Kong build, using bridged, you can connect to the internet. If I used the unbridged approach and any of the two methods referred to in the documents in the above post, I do not get access to the internet.
On Netgear R8000 with BS experimental drivers build issued on June 10, 2020, whether it is bridged or unbridged, and if unbridged I use any of the two methods in the documents in the above post, I do not get access to the internet.
When I check the traffic on the vap, there is zero transmission sent or received when there is no access to the internet.
I do not know if this is relevant but I have two routers, Netgear R8000 is the primary router with dhcp,WAN, enable with dhcp server. Netgear R6250 is the secondary router with WAN disabled along with dhcp server disabled. The secondary server gets access to the internet from the primary server.
In the bridge mode, the ip address is the same for both the private and guest network if I signed out of one and sign in to the other.