I still have (and read a lot in this forum) Wifi issues.
Devices are get kicked out every few hours and when i try to connect them i receive the error: Wifi code in corrected.
Also in syslog i see errors coming every minute (errors about hostapd and deauthenticated due to inactivity (timer DEAUTH/REMOVE).
I read many try solutions but can this be fixed in the new builds?
And which build is error free, no Wifi problems, hostapd and deauthenticated problems?
Joined: 08 May 2018 Posts: 14207 Location: Texas, USA
Posted: Wed Apr 08, 2020 12:59 Post subject:
In the WRT32X install thread I linked, there was some talk about disabling the ath2 device because it was specifically for DFS and has no external antenna, but there was a post about a build where all work. The thing is, if ath2 is hard-coded to only use certain channels or some such, then it should be turned off because it is of no use. YMMV. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
In the WRT32X install thread I linked, there was some talk about disabling the ath2 device because it was specifically for DFS and has no external antenna, but there was a post about a build where all work. The thing is, if ath2 is hard-coded to only use certain channels or some such, then it should be turned off because it is of no use. YMMV.
Alright, I have set it off. Thanks for your answer kernel-panic69!
I run some tests and I notice when I disable ATH1 (Wireless 2.4Ghz) I receive no more errors. All my clients are then off course connected to the ATH0 (Wireless 5Ghz).
So it has to do something with ATH1, the wireless 2.4Ghz band.
I did try to change this band to Mixed/NG-Mixed/N-Only but did receive the same errors.