Posted: Fri Feb 21, 2020 4:41 Post subject: Flashed wrt1900acs and no answer
Hi.
I've just installed the last build, everything was fine, put the new password, checked 2-3 things and I decided that i wanted to do a reset as some seem to say.. so I made a reset on my fresh build and after that impossible to open the gui... 192.168.1.1.. edge, chrome, firefox,private window etc..
Impossible.. no access.
Joined: 08 May 2018 Posts: 14246 Location: Texas, USA
Posted: Fri Feb 21, 2020 5:18 Post subject:
DId you happen to save the user/pass to your browser? This is why I generally do not do a reset when upgrading. Because it is usually not necessary. I would clear your browser cache and check to see if the user/pass was saved and delete it and then see if that makes a difference. How exactly did you "reset" the router? _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
DId you happen to save the user/pass to your browser? This is why I generally do not do a reset when upgrading. Because it is usually not necessary. I would clear your browser cache and check to see if the user/pass was saved and delete it and then see if that makes a difference. How exactly did you "reset" the router?
I'm fine finally. I made 3 times reboot method and finally i rebooted the stock firmware .... dont know what happened
This appears to be an issue with r42460. The 5 ghz radio refuses to come up on 3200acm. _________________ WRT3200ACM - Firmware: DD-WRT v3.0-r35681 std (04/06/18).
WRT160N - Repeater - Firmware: DD-WRT v24-sp2 (02/02/15) mini.
I encountered the same situation with a Linksys WRT1900ACv2.
Could not access thru Gui or telnet or SSH. Also needed to 3 reboot to partition 2 to recover. Tried twice with same results.
I can't really add anything for researching problem but
I do have two physical hard drives connected via USB port and eSata/2.0 port and enabled via NAS.
Both formatted NTFS thru Windows 10 B4 connecting to router.
I had them unplugged before I finally was able to recover.
I hesitate to try again until I see more discussion.
And "no" I am not an advanced user. Closer to the newbe end of the scale.
As I said, I'm ok now. But I waited 15 minutes. Rebooted, disconnected the router, tried 3 browsers etc and nothing. So after the 3x rebooting method the router switched the partition and I reflashed with the last build.
Question : in first, I flashed from the linksys firmware, after that, the dd wrt firmware was no longer responding so I rebooted on the other partition (linksys)
And I reflashed with dd wrt again. SO, my 2 partitions have dd wrt now?
Thanks
From the Linksys web interface you overwrote the existing DD-WRT partition.
I take the webflash right?
No. The factory to dd-wrt.
Reslly? Cause I've already have a dd wrt build on my router, I just want to install the other build.. some days ago.
You always have to use factory to dd-wrt from the Linksys web interface. _________________ WRT3200ACM - Firmware: DD-WRT v3.0-r35681 std (04/06/18).
WRT160N - Repeater - Firmware: DD-WRT v24-sp2 (02/02/15) mini.