Initial impressions are something has sped up. DNS response is much faster. I will keep an eye on it. _________________ Netgear R9000 X10
DD-WRT v3.0-r42460 std (02/20/20)
AP, DNSMasq, Local DNS
QoS using HFSC w/FQ_CODEL_FAST
ACK, SYN, FIN, RST
Static Leases & DHCP
2.4GHz: 3 + 7 (2422 MHz HT40)
5GHz: 100 + 114 (5500 MHz VHT160)
Netgear R7500V2 WDS STA
DD-WRT v3.0-r42366 std (2/114/20)
SCP/CLI wireless upgrade over 42353 no reset
All working. Thanks BrainSlayer
i use proftpd daily with dd-wrt on my nas. it just works. since you are using proftp on opt and some other non official folders, i assume you configured proftpd by hand. so configure it right or use the standard dd-wrt way which uses /mnt/xxxx as path for storage devices. and the type of filesystem is totally irrelevant. except you are using chinese or other strange characters (kyrillic) in your filenames. then you cannot use proftpd at all on alot of filesystems which is a limitation of proftpd and very hard to fix without increasing the binary size of the ftp server alot
alot of troubles can be also solved with mount options since you likelly mounted them manually or custom. _________________ one cigarette costs 2 minutes of your life.
one bottle of beer costs 4 minutes of your life.
one working day costs 8 hours of your life.
Linux DD-WRT 4.14.8 #42 SMP PREEMPT Thu Dec 21 18:11:16 CET 2017 armv7l DD-WRT
root@DD-WRT:/sys# nvram get DD_BOARD
r7800 latency is on par with kong builds, but the cpu usage for sirq on wifi interfaces is still broken and over 3x higher than kong builds and BS k3.18 builds.. if the r7800 was doing nat+qos, it still would be choking at these speeds from not enough cpu free.. keep the latency the same and fix the cpu usage, this will be finally 100% fixed for the first time..
kong r40720m firewall/qos/nat disabled, 5ghz sirq cpu load @ 320mbps:
ANY k4.x bs build firewall/qos/nat disabled, 5ghz sirq cpu load @ 320mbps:
Posted: Sat Feb 15, 2020 11:02 Post subject: TP-Link TL-WDR3600 v1 - 02-14-2020-r42366 WiFi
Router Model: TP-Link TL-WDR3600 v1
Firmware Version: DD-WRT v3.0-r42366 std (02/14/20)
Linux 3.10.108-d10 #38381 Fri Feb 14 07:14:07 +04 2020 mips
Status: Working, WiFi issue
When Wireless SSID Broadcast is disabled Android device stop connecting with AP (tested on Samsung Android 9 and Huawei Android 9 - 2,4 GHz and 5GHz).
I tried to delete and add a network profile again - no luck. WPA2-PSK
Windows 10 device connect as before.
Network analyzer software run on Android sees broadcast from hidden AP.
When I change Wireless SSID Broadcast to enabled i can connect.