Joined: 19 May 2007 Posts: 283 Location: Los Angeles, CA USA
Posted: Fri Jan 10, 2020 21:21 Post subject: bricked wrt1200ac v1 (solved)
hello everyone, i bricked my wrt1200ac a while back when i flashed ddwrt to it. the accessing the second partition via on/off power did not work so i gave up and put it away. now i have some time to work with it. can you guys tell if it is recoverable by looking at the following log?
USB3.0 0: Host Mode
Board configuration detected:
mvEthE6171SwitchBasicInit init
Net:
| port | Interface | PHY address |
|--------|-----------|--------------|
| egiga0 | RGMII | 0x01 |
| egiga1 | SGMII | 0x00 |
egiga0 [PRIME], egiga1
auto_recovery_check changes bootcmd: run altnandboot
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x3200000, size 0x600000
6291456 bytes read: OK
## Booting kernel from Legacy Image at 02000000 ...
Image Name: DD-WRT
Created: 2018-05-07 1:31:30 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2156801 Bytes = 2.1 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
Marvell>>
if it is recoverable, where do i start? please point me in the right direction. thank you. _________________ e3200 stock <- waiting for support
wrt400n v26 std with modded antennas
Last edited by lceron on Mon Jan 20, 2020 16:51; edited 1 time in total
Joined: 19 May 2007 Posts: 283 Location: Los Angeles, CA USA
Posted: Sun Jan 19, 2020 21:36 Post subject:
good news, i was able to recover my wrt1200ac from nasty bad flash...thanks for all the help and information provided. thanks again. _________________ e3200 stock <- waiting for support
wrt400n v26 std with modded antennas
