bad BAD BAD, usual poor k4.x ipq806x performance. about doubled the cpu load with sirq, latency is high, wifi throughput is jittery and low etc, even when bridged with no nat/firewall/qos enabled on the r7800. and BS has "no issues"... (r7800). ipq806x is trashed by kernel 4.x even after all these years. seems kong was the only one on earth able to fix it..
kong r40720m firewall/qos/nat disabled, 5ghz sirq cpu load @ 320mbps:
core0: 15%
core1: 3%
latency good
ANY k4.x bs build firewall/qos/nat disabled, 5ghz sirq cpu load @ 320mbps:
core0: 60%
core1: 40%
wifi latency completely terrible, and throughput is LOW. and im still unbelieved by bs as hes shrugging this off looking at iperf numbers "seems fine" etc. _________________ LATEST FIRMWARE(S)
BrainSlayer wrote:
we just do it since we do not like any restrictions enforced by stupid cocaine snorting managers
EA8500 ---main router
DD-WRT v3.0-r41586 std (11/21/19)
Linux 4.9.202 #493 SMP Wed Nov 20 03:52:57 CET 2019 armv7l
No reset ...GUI install over r41580 --- seems good for me
ovpn server, VLAN, unbound, samba ...All Good
:~# uptime
04:21:04 up 22:30, load average: 0.02, 0.02, 0.00
:~# date
Fri Nov 22 04:21:06 CST 2019
:~#
WNDR3700 V4
DD-WRT v3.0-r41586 std (11/21/19)
Linux 3.18.140 #59880 Thu Nov 21 09:58:07 +04 2019 mips
No reset ...GUI install over r41580 ...working fine on this unit
:~# uptime
04:22:05 up 22:25, load average: 0.00, 0.00, 0.00
:~# date
Fri Nov 22 04:22:07 CST 2019
:~#
Joined: 16 Nov 2015 Posts: 6447 Location: UK, London, just across the river..
Posted: Fri Nov 22, 2019 15:25 Post subject:
Router Model TP-Link WR1043ND V2
Firmware Version DD-WRT v3.0-r41586 std (11/21/19)
Kernel Version Linux 3.18.140 #59854 Thu Nov 21 09:20:41 +04 2019 mips
update: CLI
reset: NO
status: Operational 1 day +
errors: Nothing new for my set up...will report if anything so far so good... _________________ Atheros
TP-Link WR740Nv1 ---DD-WRT 55630 WAP
TP-Link WR1043NDv2 -DD-WRT 55723 Gateway/DoT,Forced DNS,Ad-Block,Firewall,x4VLAN,VPN
TP-Link WR1043NDv2 -Gargoyle OS 1.15.x AP,DNS,QoS,Quotas
Qualcomm-Atheros
Netgear XR500 --DD-WRT 55779 Gateway/DoH,Forced DNS,AP Isolation,4VLAN,Ad-Block,Firewall,Vanilla
Netgear R7800 --DD-WRT 55819 Gateway/DoT,AD-Block,Forced DNS,AP&Net Isolation,x3VLAN,Firewall,Vanilla
Netgear R9000 --DD-WRT 55779 Gateway/DoT,AD-Block,AP Isolation,Firewall,Forced DNS,x2VLAN,Vanilla
Broadcom
Netgear R7000 --DD-WRT 55460 Gateway/SmartDNS/DoH,AD-Block,Firewall,Forced DNS,x3VLAN,VPN
NOT USING 5Ghz ANYWHERE
------------------------------------------------------
Stubby DNS over TLS I DNSCrypt v2 by mac913
Last edited by Alozaros on Sat Nov 23, 2019 22:45; edited 1 time in total
Router Model TP-Link TL-WR841ND v11
Firmware Version DD-WRT v3.0-r41586 std (11/21/19)
Kernel Version Linux 3.18.140 #59842 Thu Nov 21 09:13:02 +04 2019 mips
Upgrade via telnet from r41517
Reset: No
Status: Working OK as AP, HT40, NG-mixed.
Firmware Version = DD-WRT v3.0-r41517 std (11/11/19)
Kernel Version = Linux 3.10.108-d8 #27105 Mon Nov 11 03:41:05 +04 2019 mips
NOW
Firmware Version = DD-WRT v3.0-r41586 std (11/21/19)
Kernel Version = Linux 3.10.108-d8 #28026 Thu Nov 21 08:26:13 +04 2019 mips
Reset? NO
Just flashed via the browser portal and kept settings 'as is'
Errors?None*
* The usual visual bug which causes the outside (physical) 5 GHz light not to be on. Yet the 5 GHz is working. Which means it is safe to ignore. You don't actually need a blinking light to have it work.
-------------
EDIT again:
iffin yous people care the page linked to above has been updated --- now has link to r41631 and she is also goodn
http://www.dslreports.com/speedtest/56903307