Posted: Sun Mar 17, 2019 17:13 Post subject: Help me I can not bricked me router tplink wr941nd
Somebody help me.
It's going to go with me like this and I can not bricked me router tplink wr941nd ver. 3.6..
It only writes to me and does not go anymore, can anyone tell me where to go wrong?
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
bsingle_phy = 0
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... Error: Bad gzipped data
GUNZIP ERROR - must RESET board to recover
Autobooting in 1
ar7100>
ar7100> tftp 0xa0800000 openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin
set link to 100M full by lqm.
dup 1 speed 100
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08
checksum bad
checksum bad
checksum bad
T T T T T T T T T T T
Retry count exceeded; starting again
set link to 100M full by lqm.
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08 T T T T T
Posted: Tue Oct 22, 2019 19:27 Post subject: Re: Help me I can not bricked me router tplink wr941nd
krste wrote:
Somebody help me.
It's going to go with me like this and I can not bricked me router tplink wr941nd ver. 3.6..
It only writes to me and does not go anymore, can anyone tell me where to go wrong?
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
bsingle_phy = 0
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... Error: Bad gzipped data
GUNZIP ERROR - must RESET board to recover
Autobooting in 1
ar7100>
ar7100> tftp 0xa0800000 openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin
set link to 100M full by lqm.
dup 1 speed 100
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08
checksum bad
checksum bad
checksum bad
T T T T T T T T T T T
Retry count exceeded; starting again
set link to 100M full by lqm.
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08 T T T T T
Das heruntergeladene openwrt Image file scheint defekt oder der download wird nicht binär durchgeführt. Prüfen ob im TFTP Progamm auf dem PC das Programm in binär Übertragungsmodus (binary mode) gesetzt werden muss, um ausführbaren code korrekt zu übertragen.