Flashed with FF68.0.1x64. No issues. I had OpenVPN connected when I upgraded, after the reboot the settings were still on for VPN but the VPN was not connected. I rebooted again and the VPN connected but there was no DNS service. Reverted to 40134.
When I had the 7/29 version running, and DNS seemed to not work, I did a tracert:
Tracing route to dd-wrt.com [185.84.6.111]
over a maximum of 30 hops:
Tracing route to dd-wrt.com [185.84.6.111]
over a maximum of 30 hops:
1 <1 ms <1 ms <1 ms Landi_Router.local [192.168.16.128]
2 16 ms 15 ms 15 ms 10.119.0.1
3 22 ms 14 ms 15 ms 91.fc.2bd0.ip4.static.sl-reverse.com [208.43.252.145]
4 18 ms 16 ms 15 ms ae14.dar02.wdc01.networklayer.com [208.43.118.162]
5 16 ms 17 ms 15 ms ae9.bbr02.eq01.wdc02.networklayer.com [173.192.18.188]
6 17 ms 17 ms 16 ms ae6.cbs02.eq01.wdc02.networklayer.com [50.97.17.150]
7 95 ms 99 ms 96 ms ae1.cbs01.eq01.ams02.networklayer.com [50.97.17.243]
8 104 ms 102 ms 101 ms 31.10.35a9.ip4.static.sl-reverse.com [169.53.16.49]
9 104 ms ^C
Both were with ExpressVPN on. Don't know if that is any help. _________________ Netgear R9000
DD-WRT v3.0-r55819 std (04/17/24)
Linux 4.9.337 #722 SMP Wed Apr 17 04:16:49 +07 2024 armv7l
Gateway, AP, DNSMasq, Clock 2000MHz
VAP on wlan1 for internet devices
IPv4 & IPv6 (Prefix Delegation)
Static Leases & DHCP
CloudFlare, no SFE, SmartDNS, no QoS
2.4GHz: Vanilla, Airtime Fairness, NG-Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
5GHz: Vanilla, Airtime Fairness, AC/N Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
2 Netgear AX1800 WiFi Mesh Extenders
Xfinity 1.2Gbps/35Mbps
I'm using PIA so I can't say for sure with ExpresVPN
but I had to reboot my router and rooftop modem (WISP) shortly after doing this upgrade I lost the DNS. I rebooted everything then disabled VPN saved/Then reenabled VPN and saved...And everything came back up and has been working since. That worked for me but we're using different VPN/Equipment...Worth a try if you haven't already done so...
MLandi wrote:
Flashed with FF68.0.1x64. No issues. I had OpenVPN connected when I upgraded, after the reboot the settings were still on for VPN but the VPN was not connected. I rebooted again and the VPN connected but there was no DNS service. Reverted to 40134.
When I had the 7/29 version running, and DNS seemed to not work, I did a tracert:
Tracing route to dd-wrt.com [185.84.6.111]
over a maximum of 30 hops:
Tracing route to dd-wrt.com [185.84.6.111]
over a maximum of 30 hops:
1 <1 ms <1 ms <1 ms Landi_Router.local [192.168.16.128]
2 16 ms 15 ms 15 ms 10.119.0.1
3 22 ms 14 ms 15 ms 91.fc.2bd0.ip4.static.sl-reverse.com [208.43.252.145]
4 18 ms 16 ms 15 ms ae14.dar02.wdc01.networklayer.com [208.43.118.162]
5 16 ms 17 ms 15 ms ae9.bbr02.eq01.wdc02.networklayer.com [173.192.18.188]
6 17 ms 17 ms 16 ms ae6.cbs02.eq01.wdc02.networklayer.com [50.97.17.150]
7 95 ms 99 ms 96 ms ae1.cbs01.eq01.ams02.networklayer.com [50.97.17.243]
8 104 ms 102 ms 101 ms 31.10.35a9.ip4.static.sl-reverse.com [169.53.16.49]
9 104 ms ^C
Both were with ExpressVPN on. Don't know if that is any help.
LOL @ kernel-panic69 proding on the last post.
kill -9 kernel-panic69
broadcom is for people who dont like a challenge
DaveI sleeping?? whats that!! between me and him we get it out there if we cant do it on time we do it when we can bahahaha =P _________________ Downloads:
ftp site: ftp://ftp.dd-wrt.com/betas/2021 SVN Timeline:
https://svn.dd-wrt.com/timeline Commands: Misc: sleep 10;stopservice nas;stopservice wlconf;startservice wlconf;startservice nas
samba: { sleep 30; stopservice samba3; startservice samba3; } &
WRT1900ACv1: WIFI: 2.4ghz: NG-mixed, 20mhz channel width, channel follows AP, WPA2-CCMP-128.
WIFI: 5ghz: AC/N mixed, 40mhz channel width, channel 100+upper, WPA2-CCMP-128.
Misc Info: WPA2 Personal: "CCMP-128 (AES)" Static IP's VIA Mac+Host, SFE Enabled, No Rebind, Strict, no-resolv. NOTE: this is now just a wireless access point so to speak but all settings still apply to what ever wireless person connects.
OpenVPN CLIENT works fine (nordvpn server)
5GHz wpa2 CCMP-128 (AES)working fine 20MHz Mixed
2.4GHz wpa2 CCMP-128 (AES)working fine 20MHz Mixed
NAS via USB Samba also working fine
Joined: 27 Apr 2016 Posts: 112 Location: Down down .... under
Posted: Tue Jul 30, 2019 1:49 Post subject: Re: New Build: 07-29-2019-r40452
DaveI wrote:
Firmware will only flash to Partition 1 on WRT router models other than WRT3200ACM and WRT32X.
I am not going to try upgrading to anything higher than 40134 (37.5 MB, 39,325,696 bytes) on my wrt1900acv2. I'm concerned about bricking my unit with these bigger builds. Hard lesson learned in the past _________________ Linksys WRT1900ACv2 - My new go to build: DD-WRT v3.0-r44048 std (08/02/20) - STABLE
My WRT1900ACv2 has now been serving me for more than 5years Most reliable router I have ever owned!
It's not like we're making any money doing it...
I just started doing it because I keep weird hours since retiring (I sleep late and stay up late). I started noticing new releases when everybody in Euro-Land was at work and everybody on the East coast was waking up...I was still awake here on Pacific time so I would post new releases...But anybody can do it that feels they want to ... We're a Meritocracy or something like that...
PIZZEDMEOFF wrote:
DaveI sleeping?? whats that!! between me and him we get it out there if we cant do it on time we do it when we can bahahaha =P
Joined: 08 May 2018 Posts: 14221 Location: Texas, USA
Posted: Tue Jul 30, 2019 4:27 Post subject:
PIZZEDMEOFF wrote:
No weird hickups or nothing on this end so far!
LOL @ kernel-panic69 proding on the last post.
kill -9 kernel-panic69
broadcom is for people who dont like a challenge
DaveI sleeping?? whats that!! between me and him we get it out there if we cant do it on time we do it when we can bahahaha =P
DaveI wrote:
It's not like we're making any money doing it...
I just started doing it because I keep weird hours since retiring (I sleep late and stay up late). I started noticing new releases when everybody in Euro-Land was at work and everybody on the East coast was waking up...I was still awake here on Pacific time so I would post new releases...But anybody can do it that feels they want to ... We're a Meritocracy or something like that...
I was only giving a friendly nudge
FWIW, Broadcom is the oldest platform supported. Adding support for all these other manufacturers makes things challenging lol
lol