leandro.adonis86 DD-WRT Novice
Joined: 27 Jun 2019 Posts: 3
|
Posted: Thu Jun 27, 2019 17:20 Post subject: Sitecom WL342 v2 Kernel panic VFS: Unable to mount root |
|
Hello, I hope you guys can support me. I'm trying to upload firmware for my Sitecom WL342 v2 router but in certain part it do Kernel panic and reboot.
I have tried almost all "firmware.bin" v3.0 [Beta] Build versions of 3.0 from this website but same issue.
Router details from here
Additional information
Chipset RT3052
Requires ESR-9752 firmware
DD-WRT Forum: ESR-9752
RAM 16 MB
FLASH 4 MB
Here is the output from console:
Code: |
U-boot Ver:1.0.1.2 2009/09/25
Board: Ralink APSoC DRAM: 16 MB 1*16 MB
============================================
ASIC 3052_MP2 (Port5<->None)
Product Name: ESR-9752
SDRAM CAS = 3(d1835272)
============================================
Please choose the operation:
1: Load system code to SDRAM via TFTP.
1: System Load Linux to SDRAM via TFTP.
Please Input new ones /or Ctrl-C to discard
Input device IP (192.168.0.1) ==:192.168.0.1
Input server IP (192.168.0.100) ==:192.168.0.100
Input Linux Kernel filename (firmware.bin) ==:firmware.bin
Using Eth0 device
TFTP from server 192.168.0.100; our IP address is 192.168.0.1
Filename 'firmware.bin'.
Loading: *
ArpTimeoutCheck
Got ARP REPLY, set server/gtwy eth addr (00:01:29:74:30:f8)
Got it
T #
first block received
################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#########
done
Bytes transferred = 3706310 (388dc6 hex)
Linux version 3.2.102 (root@linux) (gcc version 7.1.0 (LEDE GCC 7.1.0 r4137-89c615c691) ) #6218 Wed Oct 10 15:45:22 CEST 2018
bootconsole [early0] enabled
CPU revision is: 0001964c (MIPS 24KEc)
Ralink RT3052 id:1 rev:3 running at 384.00 MHz
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Zone PFN ranges:
Normal 0x00000000 -> 0x00001000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00001000
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 rootfstype=squashfs noinitrd
PID hash table entries: 64 (order: -4, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 13632k/16384k available (1990k kernel code, 2752k reserved, 282k data, 156k init, 0k highmem)
NR_IRQS:48
console [ttyS1] enabled, bootconsole disabled
console [ttyS1] enabled, bootconsole disabled
Calibrating delay loop... 255.59 BogoMIPS (lpj=1277952)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
msgmni has been set to 26
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000500 (irq = 13) is a 16550A
serial8250: ttyS1 at MMIO 0x10000c00 (irq = 20) is a 16550A
Ralink gpio driver initialized
system type: RT3052
boot type: 0
ralink flash device: 0x1000000 at 0xbf000000
Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0022a7
Amd/Fujitsu Extended Query Table at 0x0040
Amd/Fujitsu Extended Query version 1.1.
Ralink SoC physically mapped flash: Swapping erase regions for top-boot CFI table.
number of CFI chips: 1
Creating 6 MTD partitions on "Ralink SoC physically mapped flash":
0x000000000000-0x000000030000 : "uboot"
0x000000030000-0x000000040000 : "uboot-config"
0x000000040000-0x000000050000 : "factory-defaults"
0x000000050000-0x000000120000 : "linux"
0x000000120000-0x000000400000 : "rootfs"
0x0000003f0000-0x000000400000 : "nvram"
PPP generic driver version 2.4.2
PPP BSD Compression module registered
PPP Deflate Compression module registered
PPP MPPE Compression module registered
NET: Registered protocol family 24
Ralink APSoC Hardware Watchdog Timer
u32 classifier
Performance counters on
Actions configured
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (213 buckets, 852 max)
ctnetlink v0.93: registering with nfnetlink.
IPv4 over IPv4 tunneling driver
ip_tables: (C) 2000-2006 Netfilter Core Team
IPP2P v0.8.2 loading
ipt_CLUSTERIP: ClusterIP Version 0.8 loaded successfully
TCP bic registered
TCP cubic registered
TCP westwood registered
TCP highspeed registered
TCP hybla registered
TCP htcp registered
TCP vegas registered
TCP scalable registered
NET: Registered protocol family 17
Bridge firewalling registered
8021q: 802.1Q VLAN Support v1.8
searching for nvram
nvram size = 0
nvram empty
MAC_ADRH -- : 0x0000000c
MAC_ADRL -- : 0x43305277
MAC_ADRH -- : 0x0000000c
MAC_ADRL -- : 0x43305277
Ralink APSoC Ethernet Driver Initilization. v2.0 256 rx/tx descriptors allocated, mtu = 1500!
NAPI enable, Tx Ring = 256, Rx Ring = 256
MAC_ADRH -- : 0x0000000c
MAC_ADRL -- : 0x43305277
rt3052 access driver initialization.
List of all partitions:
1f00 192 mtdblock0 (driver?)
1f01 64 mtdblock1 (driver?)
1f02 64 mtdblock2 (driver?)
1f03 832 mtdblock3 (driver?)
1f04 2944 mtdblock4 (driver?)
1f05 64 mtdblock5 (driver?)
No filesystem could mount root, tried: squashfs
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,4)
Rebooting in 1 seconds..
U-boot Ver:1.0.1.2 2009/09/25
Board: Ralink APSoC DRAM: 16 MB 1*16 MB
============================================
ASIC 3052_MP2 (Port5<->None)
Product Name: ESR-9752
SDRAM CAS = 3(d1835272)
============================================
Please choose the operation:
1: Load system code to SDRAM via TFTP.
LINUX started...
init started: BusyBox v1.7.5 (2010-06-08 17:04:18 CST)
starting pid 134, tty '/dev/console': '/sbin/config_init'
Config Init version: 1.8.1.4 date: 2010/06/08
starting pid 185, tty '/dev/ttyS1': '/sbin/config_term'
************************************************************************
* WL-342 *
************************************************************************
KernelApp/Ramdisk Ver:1.8.1.4 Date:2010/06/08
console> cat: can't open '/apps/lib/modules/2.6.21/modulesApp.dep': No such file or directory
ln: /sbin/./apps_init: File exists
console>
|
Thank you for your support.
Last edited by leandro.adonis86 on Fri Jun 28, 2019 6:10; edited 1 time in total |
|
leandro.adonis86 DD-WRT Novice
Joined: 27 Jun 2019 Posts: 3
|
Posted: Fri Jun 28, 2019 6:04 Post subject: |
|
Also did:
Unlock firmware.bin file at file proprieties.
Set the router IP to 192.168.99.9
Set your PC IP to STATIC 192.168.99.8
Router config: DHCP off, Wifi off
TFTP Apps tried: Solarwinds.Net TFTP Server, Tftpd32 by Ph. Jounin
I'm using Windows XP Home Edition SP3 x86 |
|