Unbrick TP-Link TL-WR941ND v3.6

Post new topic   Reply to topic    DD-WRT Forum Index -> Atheros WiSOC based Hardware
Author Message
DeFacto76
DD-WRT Novice


Joined: 27 Apr 2019
Posts: 3

PostPosted: Mon May 27, 2019 12:25    Post subject: Unbrick TP-Link TL-WR941ND v3.6 Reply with quote
Hello,

I have bricked my old TP-Link router and cannot unbrick it folowing the tutorials i have found on this forum. I do try it via serial, but my router does not accept command "tpl" that needs to be sent right after "Autobooting after 1 seconds". Any help would be appreciated. Thank you in advance.

    U-Boot 1.1.4 (Jan 30 2012 - 17:57:33)

    AP81 (ar7100) U-boot
    DRAM:
    sri
    32 MB
    id read 0x100000ff
    flash size 4MB, sector count = 64
    Flash: 4 MB
    Using default environment

    In: serial
    Out: serial
    Err: serial
    Net: ag7100_enet_initialize...
    No valid address in Flash. Using fixed address
    bsingle_phy = 0
    eth0: 00:03:7f:09:0b:ad
    eth0 up
    eth0
    Autobooting in 1 seconds## Booting image at bf020000 ...
    Uncompressing Kernel Image ... OK

    Starting kernel ...



    OpenWrt kernel loader for AR7XXX/AR9XXX
    Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
    Decompressing kernel...
    done!
    Starting kernel...

    [ 0.000000] Linux version 3.10.108-d8 (root@linux) (gcc version 8.2.0 (OpenWrt GCC 8.2.0 r7577-d14647dd59) ) #7605 Thu Apr 25 11:40:43 CEST 2019
    [ 0.000000] flash_size passed from bootloader = 4
    [ 0.000000] bootconsole [early0] enabled
    [ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
    [ 0.000000] booting platform Atheros AR9132 rev 2 (0xb9)
    [ 0.000000] Determined physical RAM map:
    [ 0.000000] memory: 02000000 @ 00000000 (usable)
    [ 0.000000] Zone ranges:
    [ 0.000000] Normal [mem 0x00000000-0x01ffffff]
    [ 0.000000] Movable zone start for each node
    [ 0.000000] Early memory node ranges
    [ 0.000000] node 0: [mem 0x00000000-0x01ffffff]
    [ 0.000000] Primary instruction cache 64kB, 4-way, VIPT, I-cache aliases, linesize 32 bytes.
    [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
    [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
    [ 0.000000] Kernel command line: console=ttyS0,115200 root=1f02 rootfstype=squashfs noinitrd init=/sbin/init
    [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
    [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
    [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
    [ 0.000000] Writing ErrCtl register=00000000
    [ 0.000000] Readback ErrCtl register=00000000
    [ 0.000000] Memory: 29420k/32768k available (1993k kernel code, 3348k reserved, 321k data, 180k init, 0k highmem)
    [ 0.000000] NR_IRQS:83
    [ 0.000000] irq init done
    [ 0.000000] plat_time_init: plat time init done
    [ 0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
    [ 0.080000] pid_max: default: 32768 minimum: 301
    [ 0.080000] Mount-cache hash table entries: 512
    [ 0.090000] NET: Registered protocol family 16
    [ 0.100000] Can't analyze schedule() prologue at 80066f6c
    [ 0.120000] bio: create slab <bio-0> at 0
    [ 0.120000] Switching to clocksource MIPS
    [ 0.130000] NET: Registered protocol family 2
    [ 0.130000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
    [ 0.140000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
    [ 0.150000] TCP: Hash tables configured (established 512 bind 512)
    [ 0.150000] TCP: reno registered
    [ 0.160000] UDP hash table entries: 256 (order: 0, 4096 bytes)
    [ 0.160000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
    [ 0.170000] NET: Registered protocol family 1
    [ 0.170000] gpio_proc: module loaded and /proc/gpio/ created
    [ 0.180000] Register LED Device
    [ 0.180000] wl0gpio_proc: module loaded and /proc/wl0gpio/ created
    [ 0.190000] AR7100 GPIOC major 0
    [ 0.190000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
    [ 0.200000] msgmni has been set to 57
    [ 0.210000] io scheduler noop registered
    [ 0.210000] io scheduler deadline registered (default)
    [ 0.210000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
    [ 0.240000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 19) is a 16550A
    [ 0.250000] console [ttyS0] enabled, bootconsole disabled
    [ 0.250000] console [ttyS0] enabled, bootconsole disabled
    [ 0.260000] guessed flashsize = 4M
    [ 0.270000] scanning for root partition
    [ 0.270000] ZCom quirk found
    [ 0.270000] bootloader size = F0000
    [ 0.280000]
    [ 0.280000] found squashfs at F0000
    [ 0.290000] Creating 8 MTD partitions on "ar7100-nor0":
    [ 0.290000] 0x000000000000-0x0000000f0000 : "RedBoot"
    [ 0.300000] 0x000000050000-0x0000007d0000 : "linux"
    [ 0.300000] mtd: partition "linux" extends beyond the end of device "ar7100-nor0" -- size truncated to 0x3b0000
    [ 0.320000] 0x000000050000-0x000000330000 : "rootfs"
    [ 0.320000] mtd: partition "rootfs" set to be root filesystem
    [ 0.330000] 0x000000330000-0x0000007d0000 : "ddwrt"
    [ 0.330000] mtd: partition "ddwrt" extends beyond the end of device "ar7100-nor0" -- size truncated to 0xd0000
    [ 0.350000] 0x0000003e0000-0x0000003f0000 : "nvram"
    [ 0.350000] 0x0000003f0000-0x000000400000 : "FIS directory"
    [ 0.360000] 0x0000003f0000-0x000000400000 : "board_config"
    [ 0.370000] 0x000000000000-0x000000400000 : "fullflash"
    [ 0.370000] ->Oops: flash id 0x10215 .
    [ 0.380000] PPP generic driver version 2.4.2
    [ 0.380000] PPP BSD Compression module registered
    [ 0.390000] PPP Deflate Compression module registered
    [ 0.390000] PPP MPPE Compression module registered
    [ 0.400000] NET: Registered protocol family 24
    [ 0.410000] u32 classifier
    [ 0.410000] Performance counters on
    [ 0.420000] input device check on
    [ 0.420000] Actions configured
    [ 0.420000] Netfilter messages via NETLINK v0.30.
    [ 0.430000] nf_conntrack version 0.5.0 (459 buckets, 1836 max)
    [ 0.440000] nf_conntrack_rtsp v0.7 loading
    [ 0.440000] nf_nat_rtsp v0.7 loading
    [ 0.440000] ip_tables: (C) 2000-2006 Netfilter Core Team
    [ 0.450000] TCP: westwood registered
    [ 0.450000] TCP: hybla registered
    [ 0.460000] TCP: vegas registered
    [ 0.460000] NET: Registered protocol family 17
    [ 0.460000] Bridge firewalling registered
    [ 0.470000] 8021q: 802.1Q VLAN Support v1.8
    [ 0.470000] searching for nvram
    [ 0.480000] nvram size = 65536
    [ 0.560000] nvram empty
    [ 0.560000] Atheros AR71xx hardware watchdog driver version 0.1.0
    [ 0.560000] ar71xx-wdt: timeout=15 secs (max=42) ref freq=100000000
    [ 0.570000] List of all partitions:
    [ 0.580000] 1f00 960 mtdblock0 (driver?)
    [ 0.580000] 1f01 3776 mtdblock1 (driver?)
    [ 0.590000] 1f02 2944 mtdblock2 (driver?)
    [ 0.590000] 1f03 832 mtdblock3 (driver?)
    [ 0.600000] 1f04 64 mtdblock4 (driver?)
    [ 0.600000] 1f05 64 mtdblock5 (driver?)
    [ 0.610000] 1f06 64 mtdblock6 (driver?)
    [ 0.610000] 1f07 4096 mtdblock7 (driver?)
    [ 0.620000] No filesystem could mount root, tried: squashfs
    [ 0.620000] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)
    [ 0.620000] Rebooting in 1 seconds...
Sponsor
kretex
DD-WRT User


Joined: 24 Apr 2019
Posts: 65

PostPosted: Mon May 27, 2019 16:53    Post subject: Reply with quote
did you use openwrt or ddwrt firmware before bricked?? Rolling Eyes
DeFacto76
DD-WRT Novice


Joined: 27 Apr 2019
Posts: 3

PostPosted: Tue May 28, 2019 4:47    Post subject: Reply with quote
It was openwrt.
DeFacto76
DD-WRT Novice


Joined: 27 Apr 2019
Posts: 3

PostPosted: Tue May 28, 2019 16:21    Post subject: Reply with quote
Found the problem, RX was not soldered very well.
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Atheros WiSOC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum