Joined: 25 Jun 2014 Posts: 142 Location: São Paulo - Brazil
Posted: Fri May 10, 2019 19:26 Post subject: Remote Access
Hi there, i need some help if possible.
I have 2 routers and i want to remote access both.
I can access the 1 but can't access the 2.
LAN connected, ping ok, tried DMZ on 192.168.1.2
Thank you.
Configurations
Code:
Router 1
r39715
Op Mode: Gateway
IP: 192.168.1.1
DHCP On
Firewall On
Remote Port: 50501
Code:
Router 2
r39230
Op Mode: Router
IP: 192.168.1.2
DHCP Forwarder: 192.168.1.1
Firewall Off
Remote Port: 50502
Joined: 25 Jun 2014 Posts: 142 Location: São Paulo - Brazil
Posted: Fri May 10, 2019 20:54 Post subject:
eibgrad wrote:
When you configure a router w/ Router mode, that disables NAT. And that assumes you are able to add a static route to the primary router which points to the WAN ip of that second router as the gateway to the local network behind it. Without it, internet access, either local or remote, is NOT possible.
Did you do this?
Btw, this is why we don't generally recommend using Router mode. Many times ppl are using an OEM product as their primary router, and they don't always support static routes. Gateway mode avoids a lot of these problems.
They are in the same subnet, and second router is able to get NTP and DYNDNS to work also, i guess its ok, just remote management i cant access. I will try Gateway Mode and a static route. Thank you.
Joined: 25 Jun 2014 Posts: 142 Location: São Paulo - Brazil
Posted: Sat May 11, 2019 0:55 Post subject:
I added the code to router1 startup, reboot.. and running normal. The router2 (TL-WR841ND v9) have a problem with this code, it doesn't start, no local DHCP, even fixed ip to access it localy.. no way, so i reset and tried again and upgraded the latest firmware, same, no access. I tried also with a TL-WR740 v4, this one run normal with the code.. local access ok. And about remote access, only router1 .. the new tl-wr740 with the right config.. still no remote access. Weired stuff..