krste DD-WRT Novice
Joined: 16 Mar 2019 Posts: 3
|
Posted: Sun Mar 17, 2019 13:05 Post subject: Problem bricked router tplink wr941nd ver. 3.6 |
|
Somebody help me.
It's going to go with me like this and I can not bricked me router tplink wr941nd ver. 3.6..
It only writes to me and does not go anymore, can anyone tell me where to go wrong?
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
bsingle_phy = 0
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... Error: Bad gzipped data
GUNZIP ERROR - must RESET board to recover
Autobooting in 1
ar7100>
ar7100> tftp 0xa0800000 openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin
set link to 100M full by lqm.
dup 1 speed 100
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08
checksum bad
checksum bad
checksum bad
T T T T T T T T T T T
Retry count exceeded; starting again
set link to 100M full by lqm.
Using eth0 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-ar71xx-generic-tl-wr941nd-v3-initramfs-uImage.bin'.
Load address: 0xa0800000
Loading 0x08 T T T T T |
|