[foz111]

Hi,
I know this is not DD-WRT related but i have a Version 2 Netgear D7000 router only 4 months old that i purchased 2nd hand from ebay, it worked fine for 6 weeks now i have no Wi-Fi being broadcast,
I've tried updating and downgrading firmware to no avail, obviously Netgear don't want to honer the warranty as its none transferable even though the serial number shows hardware still covered.
I've tried a 30-30-30 reset also but this no longer seems to reset the router? nothing seems to change. holding the reset in for 8 seconds does a factory reset but i was hoping to do a deeper reset on the nvram.
My thoughts were to try a serial connection and reset the nvram from putty and flash it from putty hoping this may bring them back to life or do you guys feel its a waste of time and its a hardware issue like on the r8500?
i can seem read it with the serial but no CFE with Ctrl-C. From memory i get RFX (i will try it again later but thought i would ask on here as i know you guys are the most knowledgeable around.
thanks for any input you may have

[egc]

Try TFTP or NMRP flash.
In the thread of the R6400v2 (see signature) there is a debricking guide in the second post this applies to most Netgear routers

[foz111]

thanks for your reply,
output from serial below

ROM VER: 2.1.0
CFG 0a
B
.
.


U-Boot 2010.06-LANTIQ-v-2.3.136 (Jun 16 2017 - 09:41:44)

interAptiv
cps cpu/ddr run in 800/666 Mhz
DRAM: 224 MiB
NAND: ONFI flash detected
ONFI param page 0 valid
NAND device: Manufacturer ID: 0x01, Chip ID: 0xf1 (AMD S34ML01G2)
128 MiB
Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01
In: serial
Out: serial
Err: serial
Net: multi type
Internal phy firmware version: 0x853c
GRX500 Switch

Type "run flash_nfs" to mount root filesystem over NFS

LED done
Hit any key to stop autoboot: 0
GRX500 #

[foz111]

is this:-
"Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01 "
causing the router not to broadcast SSID?