[Wolfate]

Hi there,

I need to automate the configs for a number of access points and I've been straggling with this for a while, I've managed to figure out how to use nvram to set vifs for exmaple for the wl0 interface like so "wl0_vifs="wl0.1 wl0.2 wl0.3" and how to use nvram to set the ssids, bssids, etc. But the wl0.x interface is not showing in linux so I can bridge it with right interface, which also causing it not broadcast the ssid. Adding the virtual interface from the webgui works fine though. I've already diff'ed the nvram show before and after adding the vifs from the webgui, but it didn't give me any clues.

I'm suspecting that the command I need is in wl command line, but I couldn't figure out how. I appreciate any help.